Panasonic 700 User Guide
Appendix B. CPC-AII/B 8.0 Feature Update
Section 700-Operation
Page B-10
DBS Manual - Revised April 2000
DBS-2.3/9.2-700
• The
*61
code toggles Variable Mode on and off. Press
ON/OFF *61
ON/OFF
again to turn Variable Mode off.
2.
While the extension is engaged in an intercom call, the 2nd line
will display select key 1 and 2 features from the Flexible
Function Screen assigned to display in FF3 ExtPort# 28#. The
same applies when the extension receives CO dial tone (FF3
ExtPort# 29#); during a trunk call (FF3 ExtPort# 30#); and
after dialing a busy extension (FF3 ExtPort# 33#).
• Use existing addresses FF1 2# 7# 1# thru 4# to assign select
will display select key 1 and 2 features from the Flexible
Function Screen assigned to display in FF3 ExtPort# 28#. The
same applies when the extension receives CO dial tone (FF3
ExtPort# 29#); during a trunk call (FF3 ExtPort# 30#); and
after dialing a busy extension (FF3 ExtPort# 33#).
• Use existing addresses FF1 2# 7# 1# thru 4# to assign select
key features to Flexible Function Screens.
• Select key features for Fixed Function Screens will not
appear on small-display phones.
3.
While the select key feature is displayed, you can execute the
feature by pressing the > or < select key.
feature by pressing the > or < select key.
Notes
Toggling Variable Mode On/Off with an FF-Key. You can program the
*61
code into an FF-key: In programming mode, press FF5 (ExtPort)#
(KeyNo.)# (*61)#. The FF-key will toggle Variable Mode on/off while the
extension is idle or in an off-hook/dial-tone state. The FF-key LED will
remain lit (red) while Variable Mode is “On”. (You can also use a one-
touch key to toggle Variable Mode on and off; however, one-touch keys do
not contain an LED to indicate when Variable Mode is on.)
extension is idle or in an off-hook/dial-tone state. The FF-key LED will
remain lit (red) while Variable Mode is “On”. (You can also use a one-
touch key to toggle Variable Mode on and off; however, one-touch keys do
not contain an LED to indicate when Variable Mode is on.)
Variable Mode After Power-Cycling. If Variable Mode is “On”, the
extension will stay in Variable Mode even after power-cycling (system is
powered down, then powered back up).
extension will stay in Variable Mode even after power-cycling (system is
powered down, then powered back up).
Incompatibility with older phone versions. Variable Mode is available on
the 44-Series phones only.
the 44-Series phones only.
Conditions under which Variable Mode does not work. Variable Mode
will be temporarily overridden under the following conditions: during an
incoming message state, hold state, message-waiting state, or call-waiting
state. Incoming messages include:
will be temporarily overridden under the following conditions: during an
incoming message state, hold state, message-waiting state, or call-waiting
state. Incoming messages include:
CO Queuing
Incoming [trunk no.]
REV.[extension no.]
TRF.[trunk no.]
H-Recall
Call Wait
REC.[trunk no.]
Recall Hnt [Hunt Group no.]
DISA Incoming
Call [extension no.]
Transf [extension no.]
Recall [trunk no.]
HOLD Recall
Incoming [trunk no.]
REV.[extension no.]
TRF.[trunk no.]
H-Recall
Call Wait
REC.[trunk no.]
Recall Hnt [Hunt Group no.]
DISA Incoming
Call [extension no.]
Transf [extension no.]
Recall [trunk no.]
HOLD Recall