Panasonic 700 User Guide
Appendix B. CPC-AII/B 8.0 Feature Update
Section 700-Operation
Page B-14
DBS Manual - Revised April 2000
DBS-2.3/9.2-700
Incoming Calls
• You cannot program both devices to ring simultaneously.
• You cannot program both devices to ring simultaneously.
• The “*71” code will not work if the other device is in use.
• The “*71” code will not work if FF3 (ExtPort)# 51# is set to “0”.
• If set to “Analog port RING”, the large-display phone will work like an
SLT/OPX (no page announcements, no voice calls from other
extensions, etc.).
extensions, etc.).
• If the phone is in CF/DND (Call-Forward or Do Not Disturb), the phone
will remain in CF/DND even if the ringing device is changed via the
*71 code.
*71 code.
• The incoming ring pattern for the analog device is the same as for the
digital key telephone (determined by the Extension Ring Pattern in FF3
(ExtPort)# 39# (0-9)#). If this address is set to “0” (determined by CO),
the analog device will automatically default to “1 second ON, 3 seconds
OFF.”
(ExtPort)# 39# (0-9)#). If this address is set to “0” (determined by CO),
the analog device will automatically default to “1 second ON, 3 seconds
OFF.”
Ring Patterns Not Applicable to Analog Device. The following ring
pattern addresses will not affect the analog device:
pattern addresses will not affect the analog device:
Analog Transfer Ring Pattern FF1 2# 1# 31# (0-6)#
SLT DISA Ring Pattern
SLT DISA Ring Pattern
FF1 2# 1# 34# (0 or 1)#
Inbound Ring Pattern
FF2 (Trunk)# 17# (0-9)#
Flash Interaction. Any disconnect signal sent to the analog port must be
greater than the SLT Flash Control; otherwise the disconnect signal will be
interpreted as a flash and the call will be placed on hold.
greater than the SLT Flash Control; otherwise the disconnect signal will be
interpreted as a flash and the call will be placed on hold.
Programming Addresses That Affect the Analog Device. The following
addresses will control the analog device, but will not affect the digital key
telephone:
addresses will control the analog device, but will not affect the digital key
telephone:
AEC Disconnect Duration
FF1 2# 1# 35# (0-15)#
SLT Flash Control
FF1 2# 1# 11# (0 or 1)#
SLT Onhook Flash Timer
FF1 3# 14# (0-6)#
AEC Disconnect
FF3 (ExtPort)# 46# (0
or 1)#
Analog Port on Large-Display Phone
Analog Port on Large-Display Phone
FF3 (ExtPort)# 51# (0
or 1)#
Data Security on Analog Port
Data Security on Analog Port
FF3 (ExtPort)# 52# (0
or 1)#