Panasonic 700 User Guide

Appendix I. CPC-EX 2.3 Feature Update

Section 700-Operation

Page I-12

DBS Manual - Revised April 2000

DBS-2.3/9.2-700

• You must enter programming using the private password to view the 

private password address. The private password address will not appear 
and is not accessible if programming is entered using the system or remote 
password.

• If the system or remote password is set to the same value as the private 

password, then the private password address will not be accessible. You 
must first change the system or remote password to another value and then 
log in again using the private password to have access to the private 
password address.

• If you are at an attendant key telephone when entering programming, you 

must first enter #98 followed by the 4-digit private password before 
entering programming (see below). Otherwise, the private password is not 
accessible. 

To access the system using the private password at any display key telephone 
(including an attendant telephone):

1.  Go off-hook or press ON/OFF key.

2. Dial #98 followed by the 4-digit private password.

3. Press PROG followed by ##.

4.  To exit system programming, hang up or press the ON/OFF key.

When programming from a terminal connected to the RS-232C (SMDR) port, 
perform the following steps:

1.  Make certain the cables are configured and connected as outlined in 

Section 300.

2.  Make certain the DBS is in the SMDR mode by entering the following 

code from the attendant port:

3.  Enter your terminal communications program and make sure your PC's 

data communications settings match those of the DBS.

4.  From your terminal communications program, type the following 

command: