Panasonic 700 User Guide
Chapter 3. System Features
Section 700 - Operation
Page 3-16
DBS Manual - Revised April 2000
DBS-2.3/9.2-700
Centrex/PBX Compatibility
(CPC-A Version 3.2 or higher, CPC-AII, and CPC-B Version 2.1 or higher)
Description
Centrex/PBX Compatibility allows the DBS to be connected to centrex or
PBX lines.
PBX lines.
The DBS supports up to 8 access codes for dialing centrex or a PBX. These
access codes allow the DBS SMDR output to exclude the number dialed to
reach a centrex or PBX line.
access codes allow the DBS SMDR output to exclude the number dialed to
reach a centrex or PBX line.
The DBS also supports transmission of a flash signal over the centrex or PBX
link.
link.
Related Programming
• FF1 (System): PBX Access Code(s)
• FF2 (Trunks): Trunk Type
• FF8 (Least Cost Routing): LCR Add Tables
Considerations
• The LCR Add Table can be used to prefix digits for outgoing calls through
Centrex.
Direct Inward Dialing (DID)
(CPC-B Version 2.0 or higher)
Description
The Direct Inward Dialing (DID) feature allows an extension to have a
dedicated direct number. The dedicated number allows calls to be made
directly to the extension, without the caller going through the attendant.
dedicated direct number. The dedicated number allows calls to be made
directly to the extension, without the caller going through the attendant.
Prior to CPC-B Version 3.1, only one DID number could be assigned to an
extension. Beginning with CPC-B Version 3.1, one DID number can be
assigned to several extensions, and one extension can have more than one
DID number; this is also true of CPC-AII.
extension. Beginning with CPC-B Version 3.1, one DID number can be
assigned to several extensions, and one extension can have more than one
DID number; this is also true of CPC-AII.
If a DID number is assigned to more than one extension, incoming calls to the
DID number ring at all the assigned extensions simultaneously.
DID number ring at all the assigned extensions simultaneously.