Eureka! Tents 2XTE User Manual

fig.8  

fig.7  

fig.9 

fig.6

Component List:
1 Tent Body   1 Tent Fly   1 Carry Bag   2 Tent Poles  1 Pole Bag   1 Fly Rod   
14 Stakes & 4 Guy Ropes w/Bag          1 Gear Loft     

• Turn the fly right side up and drape it over the tent with 

the fly rod pointing over a door. Align the orange web on 

the fly to the orange web on the tent. 

• Reach under the fly and wrap each Velcro® strap around 

its pole. See fig.10.

• Attach the clips from the fly to the rings near the floor on 

each side of the tent. See fig.11. 

• Attach the web buckle from each corner of the fly to its 

mate on the tent web. See fig.12. Adjust the corner webs 

to proper tension. Pull out the side webs, stake down and 

adjust. Take care, the fly must not contact the tent wall.

• Lift the side vents to open and secure the support arm to 

the Velcro® tab. See fig.13.

• Attach a guy-out cord to each corner loop and stake them 

out. See fig.14.

• Working your way around the 

tent, attach all the clips from the 

corners of tent to the poles. See 

fig.6 & 7.

• The tent is now freestanding. 

Place it in the desired location.

• Raise both poles over the center of the tent 

and secure to the tent fabric with the loop / 

dog bone. Capture both poles at the top. See 

fig.4 and 5.

• With the poles and tent body 

firmly attached, square the 

tent and pull the wrinkles 

out of the floor. Use a 

metal skewer to stake 

out each corner web. 

See fig.7.

• Pull up stakes, remove the fly and open tent doors. Pull posts out of the grommets 

and remove the clips. Collapse the tent poles and stow. Fold the tent and fly. Lay the 

fly and poles on the folded tent. Roll up all towards the door and stow.

NOTE:
Do not drop tent bag or pole bag on its end. Do not bounce tent bag on its end to get 
the tent out. These actions may cut the shock cord and/or damage the pole ends.

• Unpack the tent bag. Unfold the tent and lay it out, with the floor on the 

ground with a grommeted web in each corner. Pull the tent into a rough 

rectangle. Do not stake down the tent just yet; but in windy conditions, 

stake down one corner that faces into the wind.

• Assemble the shock corded long tent poles and shorter fly rod. Carefully 

seat each section. Try to keep the poles from snapping together as this 

can damage the ends.

• At the front of the tent body at 

A, lay a long tent pole diagonally across 

the tent to the  opposite side 

B. Do the same with the second long pole 

from 

C to D. See fig.1.

REV  C 4.09

• Insert the post end of a 

pole into a grommet on 

the corner stake-out web. 

See fig.2.

• At the opposite corner, grasp the web and simultaneously push the 

pole to form an arc. Insert the post end into the grommet on the 

corner stake-out web. Do this again with the second pole. See fig.3.  

• Unroll the fly, upside down, on the ground. Locate the web pockets on 

the fly and insert the assembled fly rod into these pockets. Wrap the 

Velcro® strap around the center of the fly rod. See fig.8 & fig.9.

fig.10  

fig.11  

fig.13

fig.12 

fig.4  

fig.5

fig.1

fig.3

fig.2