Eureka! Tents Dominion User Manual

fig.7

fig.8

fig.9

Component List:
1 Tent Body,    2 Tent Poles,    1 Carry Bag,    
1 Tent Fly,    1 Stake Bag/ Stakes 

Unroll and unfold the tent with the floor on the ground.  
Remove the fly and set it aside. Do not stake the tent down 
yet. In windy conditions, we recommend that the mesh end 
should face into the wind and that you stake down one 
corner of this end.

Join the shockcorded poles. Try to prevent pole sections 
from snapping together, as this can damage the pole ends. 
NOTE: Make certain each insert end has seated firmly into 
each plain end.

At the front corner of the 
tent- 

A, slide the ball end of 

one of the aluminum poles 
into the rod sleeve. Angle 
the pole to the opposite 
corner; 

A to C. At corner B, 

repeat with the second pole 
and sleeve; 

B to D. 

See fig. 1 and 2.

Start at the front of the tent at 

D, 

grasp the end of the pole in one hand 
and the web loop in the other. Push 
the pole from 

D to B creating an arc. 

Insert the pin into the pole ferrule to 
maintain tension across the seam line. 
Repeat with the other pole; 

C to A. 

See fig. 3 and 4.

With the tent secure, drape the fly over the tent body. The fly 
only fits on the tent one way. Position the fly over the tent with 
the vestibule wing sections over the doors and with the ! section 
over the all mesh end of the tent. Reach under the fly and 
connect the hook and loop tabs to the tent poles.  See fig. 7.

Connect the four corner buckles on the fly to their mates on the 
tent webs. Do not fully tighten down any of the webs just yet.
See fig 8.

At the front of the tent, pull the stake out loop on the vestibule 
taut and stake it down. Make sure that the vestibule is tight 
across the door.  Repeat with the other vestibule at the rear of 
the tent. 
See fig.9.

With the vestibule wing sections staked down and tight, go to 
the open side of the tent, pull out the vent and hold in place 
with the hook and loop tab. Then adjust and tighten all the 
remaining side release buckles. 

NOTE: 
In strong winds, tie extra guy lines to the storm loops on the 
fly and stake down so that the lines are tight.

REV B  4.09

fig. 1

fig. 2

fig. 3

fig. 4

fig. 5

fig. 6

Raise up the tent poles and attach the peak of the tent to 
them. Capture both poles where they cross, with the top 
tent clips. Then attach all remaining clips to the poles. 

Your tent is now free-standing, 
place it in location that has enough 
room for the fly and stake it down 
through the corner rings. Stake the 
opposite corners while applying 
tension to smooth the floor 
wrinkles. NOTE: General purpose 
stakes are included but snow or 
sand stakes can be purchased at a 
Eureka! dealer. 
See fig 5 and 6.