Eureka! Tents Breezeway User Manual

REV D  4.09

1 Screen/Body w/ Hub  

1 Tent Bag 

1 Pole Bag

4 Poles          

1 Stake Bag and Stakes

You can usually assemble this Breezeway alone. However, with first

time set-up or with windy conditions, you will need help.

fig.6

fig.4

fig.2

fig.3

fig.1

fig.5

fig.7

fig.8

1. Unpack the tent bag, pole bag and separate all of the components.

    Unroll and unfold the fabric with the Eureka! label up.

3. Assemble all of the shock-corded poles. Check and make sure that

    each section is fully seated into the next. See fig.2.

2. Locate the spider hub fitting attached to the center of the roof. 

    See fig.1.

4. Slide a top pole section onto a spider hub arm. See fig.3.

5. Check and make sure the hub and fabric are aligned. 

    Then, insert the proper corner ring & pin into the bottom 

    pole section. See fig.4. 

6. Repeat with a second pole onto the opposite hub arm 

    to form and arch. Lift the arch; attach the remaining two 

    poles to erect a free standing unit. See fig. 5.

Take down:  
 

• Zip the doors closed. 

 

• Unstake the Breezeway. 

 

• Unclip the fabric from the frame. 

 

• Remove the corner pins from the ends of the poles. 

 

• Remove the poles from the hub, unseat each section and

         store in the pole bag. 
 

• Fold the fabric into thirds. Place the pole bag on the fabric 

         and together, roll them up.
 

• Pack all components into the tent bag.

 

7. Attach all of the top pole clips. Attach the bungee cords 

    to all the corner hooks. Then attach all remaining clips.  

See fig.6. 
8. Stake down all four corner rings and your 

    Breezeway is ready. See figs.7 & 8.

®