Eureka! Tents JUNO 3XTA User Manual

fig 7

fig 8

fig 9

Component List:
1 Tent Body,      2 Tent Poles,      1 Carry Bag,    
1 Tent Fly,          1 Stake Bag/ Stakes 

Unroll and unfold the tent with the floor on the ground.  

Remove the fly and set it aside. Do not stake the tent 
down yet. In windy conditions, we recommend that the 
mesh end should face into the wind and that you stake 
down one corner of this end. 

Join the shock-corded poles together. Try to prevent 

pole sections from snapping together, as this can 
damage the pole ends. NOTE: Make certain each 
insert end has seated firmly into each plain end.

See fig 1.

At the front corner of the tent- 

A, 

slide the ball end of one of the 
aluminum poles  into the rod 
sleeve. Angle the pole to the 
opposite corner; 

A to C. At corner 

B, repeat with the second pole 
and sleeve; 

B to D. 

See fig. 1 and 2.

Start at the front of the tent at 

D, grasp the 

end of the pole in one hand and the web 
loop in the other. Push the pole from 

D to B 

creating an arc. Insert the pin into the pole 
ferrule to tension the tent across the seam 
line. Repeat with the other pole; 

C to A. 

See fig 3 and 4.

With the tent secure, drape the fly over the tent body. The fly only fits 

on the tent one way. Position the fly over the tent with the vestibule 
wing sections over the doors and with the ! section over the all mesh 
end of the tent. Reach under the fly and connect the hook and loop 
tabs to the tent poles. See fig  7.

Connect the four corner buckles on the fly to their mates on the tent 

webs. Do not fully tighten down any of the webs just yet.

See fig 8.

At the front of the tent, pull the stake out loop on the vestibule taut 

and stake it down. Make sure that the vestibule is tight across the 
door. Repeat with the second vestibule at the rear of the tent. 

See fig 9.

With the vestibule wing sections staked down and tight, go to the open 

side of the tent, pull out the vent and hold it in place with the hook 
and loop tab. Then adjust and tighten all the remaining side release 
buckles. 

NOTE: I

n strong winds, tie extra cords to the storm loops on the fly and 

stake down so that the cords are tight.

 Pull up stakes and open doors. Remove the fly. Pull pins out of 

the poles. Un-clip, collapse the tent poles and stow in the pole bag. Fold the 

tent and the fly. Roll up both along with the pole bag towards the door and 

stow all in the main bag.

REV.B 2-10

fig. 1

fig. 2

fig 3

fig 4

fig 5

fig 7

fig 6

Raise up both poles and attach the peak of 

the tent to them. Capture the poles, where 
they cross, with the tent clips. Then attach 
all remaining clips to the poles. 

See fig 5. 

Your tent is now free-standing, place it in 

location that has enough room for the fly 
and stake it down through the corner rings. 
Stake the opposite corners while applying 
tension to smooth the floor wrinkles. 

See fig 6 and 7.

NOTE: General purpose stakes are included 

but snow or sand stakes can be purchased 
at a Eureka! dealer.