Eureka! Tents Hex Screen House User Manual

fig.6

fig.4

fig.2

fig.3

fig.1

fig.5

fig.7

 

    

 

REV  E  10.09

You can usually assemble this screen house alone. However, 

with first time set-up or with windy conditions, you will 

need help.

1 Screen/Body w/ Hub   1 Tent Bag   1 Pole Bag

6 Rafters   6 Poles  1 Stake Bag and Stakes

• Unpack the tent bag, pole bag and separate all of the 

components. Choose a suitable place and unroll and 

unfold the fabric with the Eureka! label up.

• Assemble all of the chain-corded poles and rafters. Check 

and make sure that each section is fully seated into the 

next. See fig.2.

   Important: Locate the hub fitting attached to the center of 

the tent roof. Align the hub arms to match the layout of the 

corner pins without twisting the fabric. See fig.1.

• Slide a rafter section labeled 

"TOP" onto a hub arm.The 

spring clip must engage the 

slot in the hub arm. Repeat 

with the remaining until all 

rafters are secured in place. 

See fig.3.

• Make sure the hub and 

fabric are still aligned. 

• Insert the corner ring & pin into the bottom section of a pole. 

See fig.4. Then fit the top of the pole into the elbow of its 

coresponding rafter.

• With a second pole, fit it into the diagonal opposite rafter and 

pin to form and arch. Lift the arch, and working your way 

around the frame, attach the remaining poles to erect a 

free standing unit. 

See fig. 5. 

• Attach all of the top pole clips first. It may be necessary 

to open the doors and step inside the shelter to reach 

the clips. Then, attach all side clips. See fig.6.

• Stake down all corner rings and your Screen House is 

ready. See fig.7. 

Take down    
• Zip the door closed. 
• Unstake the screen house. 
• Unclip the fabric from the frame. 
• Remove the corner pins from the ends of the 

poles and remove from the rafters. 

• Remove the rafters from the hub. Collapse 

the sections and store in the pole bag. 

• Fold the fabric into thirds. Place the pole 

bag on the fabric and together, roll them up.

• Pack all components into the storage bag.