Eureka! Tents High Camp User Manual

Fig.2

Fig.1

Fig.11

1  

Unpack the carry bag and separate the 

components. Unfold the tent body and lay it out 

with the floor on the ground and a grommeted web 

in each corner. Pull the tent into a rough rectangle. 

Do not stake down the tent just yet; but in windy 

conditions, stake down one corner that faces into 

the wind.

2  

Orange brim rod. Carefully seat 

each section. Try to keep the poles 

from snapping together as this can 

damage the ends. Divide the Gold 

poles according to size and shape. 

Set the Orange rod aside.

3  

grommets.

   • Near each side of the door, insert 

a long Gold pole into the web 

grommet. See fig.1.

   Then arrange the poles diagonally 

across the tent from A to B and C 

to D.  See fig.2.

6

 • Slide a Gold pole through the two carabineers at the 

top of the door. Seat the post into the grommet on the 

side web at E. On the direct opposite side at F, grasp 

the end of the pole and push it up to form an arc. 

Insert the post into the web grommet at F and attach 

the clips.

• Continue with the next Gold pole from G to H. 

  Note: Seat the posts into the first grommet on the side 

webs. Whenever poles cross,capture both with the 

carabineers. See fig.6.

• Slide the Orange pole through the two carabiners in 

front of the door. Seat the post into the outside 

grommet on the side web at G. On the opposite side I 

grasp the end of the pole and push it up to form an 

arc. Insert the post into the web grommet. See fig.7.

8  

Attach the fly to the tent. 

• Spread the fly on the ground. Find the corner with reflective 

web and attach it to that corner of the tent with matching 

reflective web. Drape the fly, right side up, on top of the 

tent so that the vestibule covers the door. 

• Reach under the fly and attach all the Velcro

®

 tabs to the 

poles. See fig.9. 

• Connect the side release buckles on the fly to their mates 

on the tent. 

• Move to the rear of the tent. Use the yellow stakes to stake 

out the web loop on the back vestibule, but do not adjust 

the tension just yet. Go to the front of tent and stake out 

the two web loops on the front vestibule.

9 

Adjust the tension on the webs.  Work your way around the 

tent, tighten the web buckles until the fly/vestibule is taut. 

See fig. 10.

10 

Stake out the attached guy lines and adjust the sliders to 

a proper tension. 

  See fig.11. 

REV  B 4.09

Fig.3

Fig.4

Fig.5

Fig.6

Fig.8

Fig.7

7  

Stake the tent down. Your tent is now free standing. 

Place it in the desired location and stake it down with 

the aluminum skewers.  See fig. 8.

5 

Working your way around the tent, 

attach those carabineers and pole 

clips that align with the poles. See 

fig.4 and 5.

4  

Raise the tent. 

• At  B, push the pole from B to A to create an arc. Insert 

the locking post into the grommet on web to maintain 

tension.

• Repeat with the second pole from C to D.

• Lift both poles over the center of the tent. Lift the 

center carabineer on the tent fabric and capture both 

poles with the carabineer. Make sure the carabineer is 

locked in place. See fig.3.

Fig.9

Fig.10