Eureka! Tents Hammock User Manual

Page of 2
Component List:
1 Tent / Hammock Body w/ attached hanger assembly 
2 Attached Tent Poles      1 Carry Bag   
Assembly:
• Unroll and unfold the tent/hammock and lay it on the ground with 
  the Eureka! logo up. 
fig.2
fig.3
fig.1
fig.5
fig.7
fig.6
fig.9
fig.8
fig.10
fig.4
• There is a hanger assembly that runs the 
length of the Chrysalis  [ web, buckles, 
pins & carabiners ]. Make sure that the 
webs, buckles and carabiners protrude 
through the openings at each end and 
that the pins are held by the end web 
loops. See fig.2
• Fold the roof fabric back from the door. Inside, there are two poles 
that spread and hold the tent/hammock. Remove the protective 
covers and fit the narrow end of each pole section into the sleeve on 
its opposite half. See fig. 4 and 5.
• Adjust the webs to 
provide sufficient tension 
to hold you up off of the 
ground. See fig. 6.
• Pull the roof fabric out 
and over the pole ends 
and secure to the 
underside Velcro®.          
See fig. 7.
Note: It is easiest to enter the Chrysalis as you 
would most other hammocks. Lift the roof over 
your head, back in and sit. Turn to bring in your 
legs and lie down.
• Once inside the tent/
  hammock, you can  “shut” 
the door by attaching the 
bottom to the Velcro® on 
the outside of the shell. 
See fig. 8.
• You can hold the 
door/mesh open by 
attaching it to the ridge 
with the Velcro® straps or 
wrap the straps over the 
top to hold the fly open. 
See fig. 9.
• Or you can release the 
toggle on the inner door 
flap, fold the flap down 
and tuck it under while 
leaving the mesh in place. 
   See fig.10
• Locate the two push up vents near one 
end of the roof. At this end, wrap the 
web around a tree at approximately 
head height and secure in place with 
the carabiner. See fig.3
• At the opposite end, again wrap the 
web around a tree and secure with the 
carabiner.  Adjust tension as necessary. 
Note: If you prefer, as you lay, to have 
your head above your feet, wrap this 
web a bit lower than the first. 
REV  B   4-09
ASSEMBLY INSTRUCTIONS for the CHRYSALIS TENT/HAMMOCK:
Pin is captured
by this loop
Take down: Remove the webs from the trees. Disassemble the poles and 
replace the protective covers. Align the poles across the tent/hammock. 
Leave the doors open. Fold the fabric inward. Roll up stow in the carry bag.
YOUR TENT/HAMMOCK IS READY!
The Chrysalis is 10’ 4” 
long and needs 11’ to 15’  
of distance between 
trees or supports