Eureka! Tents Solar Shade User Manual

Component List:
1 Shelter Body,   

2 Short Poles, 1  

 Long Pole,

1 Pole Bag,  

 

1 Carry Bag,          1 Stake Bag w/Stakes,

4 Guy Out Cord  

4 Anchor Bags

ASSEMBLY:
• Unroll and unfold the shelter and lay it on the ground with 
the windows facing up.

fig.1

fig.2

fig.3

fig.5

fig.6

fig.4

• Your shelter is now freestanding. Move it to the desired 
location and secure. Since soil conditions vary greatly, we 
have included two methods to secure the shelter:
  1. On sand. Fill the four bags with sand and tie them to 
the four corner webs. Pull the bags out and away from the 
shelter until the floor is taut. Bury the bags in the sand. 
  2. On turf. Drive a stake through the grommet on a 
corner web. Work your way around the shelter, squaring 
and staking the base as you go.
See fig.5.

• Slide the long pole through the 
sleeve, across the top of the 
tent. Push the pole, don’t pull 
it. Continue until you reach 
the grommet on other side 
of the tent. Insert the post 

at the end of the pole into 
this grommet. See fig.2.

• Move back to where you started at the opposite side of 
the shelter. With the pole in one hand and web/grommet in 
the other, feed the pole up. Take care that the ferrules do 
not get caught on the sleeves. Push the pole evenly along 
its length to create an arc. Place the post end of the pole 
into the grommet to maintain tension across the top of the 
shelter. See fig.3. 

• Lift the top of the shelter. Push one of the short poles 
through a sleeve and down to a web/grommet at the base. 
At the top of the shelter, insert the post into the grommet. 
Repeat with the second pole into the last sleeve.

• Move to the base of the shelter. With a pole in one hand 
and web/grommet in the other, push the pole evenly along 
its length to create an arc. Place the post end into the 
grommet to maintain tension across the fabric. Repeat with 
the second pole. See fig.4.

REV  C  4-09 

• Assemble the shockcorded poles. Try to prevent pole 
sections from snapping together, as this can damage the 
pole ends. Make certain each insert has seated firmly into 
each plain end.
See fig. 1.

• Take down: Open door, untie 
sand bags or pull up stakes. Pull 
posts out of the grommets and 
push poles out of the sleeves. 
Collapse the poles and stow. Fold the 
shelter onto itself in thirds. Roll up towards 
the door and stow.

• Where soil conditions permit and 
when winds prevail, we recommend 
that you attach the guy out cords 
to the four loops on the sleeves 
and stake them out. Use the 
sliders on the cords to adjust 
tension. See fig.6.