Pelco C1300M-C (11/08) User Manual
40
C1300M-C (11/08)
AUX
An auxiliary output is a programmable signal from the system that can trigger another device to
operate. An auxiliary output is programmable to trigger from an alarm or from a controller.
operate. An auxiliary output is programmable to trigger from an alarm or from a controller.
An AUX 1 command from the controller will activate the relay in the system and operate the device
that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a system
switch to activate automatic monitor switching and recording.
that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a system
switch to activate automatic monitor switching and recording.
An AUX 2 command from the controller will place a ground at the output of AUX 2 to operate the
device that is connected to it.
device that is connected to it.
The following are the available AUX MODE settings:
EXIT
LANGUAGE
ENGLISH
UNIT INVERSION
OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
CYCLE CAMERA POWER
REBOOT SYSTEM
PELCO EXSITE IPSXM
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
BACK
EXIT
EXIT
UNIT SETTINGS
AUX 1 MODE
TOGGLE
DWELL TIME (SECS)
1
AUX 2 MODE
TOGGLE
DWELL TIME (SECS)
1
BACK
EXIT
EXIT
AUX
TOGGLE (default)
Changes the state of the auxiliary output every time an AUX command is
received from the controller.
received from the controller.
LATCHING
Must receive an AUX ON/AUX OFF command from the controller to turn the
auxiliary output on/off.
auxiliary output on/off.
MOMENTARY
An AUX ON command from the controller turns the auxiliary output on for the
programmed DWELL TIME. The auxiliary output will automatically turn off
when the dwell time is finished.
programmed DWELL TIME. The auxiliary output will automatically turn off
when the dwell time is finished.