Invacare 1302RTS User Manual

1.

Remove the plastic from the arms.

2.

Install the arms onto the Raised Toilet Seat.

A.

Depress both snap buttons on the arm and insert the arm into the mounting tubes.

B.

Slide the snap buttons to the appropriate holes in the mounting tubes.

3.

Repeat STEP 2 to install the opposite arm onto the Raised Toilet Seat.

4.

Put the rear wings of the Raised Toilet Seat in place underneath the 1-3/4 inch toilet lip at the back of the 
toilet bowl.

5.

Rotate the Raised Toilet Seat down until the front of the seat rests on the toilet bowl. If necessary, rotate 
the adjustment knob counterclockwise until the bracket fits inside the toilet bowl.

6.

Turn the adjustment knob clockwise to tighten the bracket against the inner surface of the toilet bowl.

FIGURE 1   Removing/Installing the Raised Toilet Seat

1.

Regular cleaning of the Raised Toilet Seat is recommended. Wipe all surfaces with a damp cloth and allow 
all surfaces to dry before use.

2.

Regular inspection of parts for deformation, corrosion, breakage, wear or compression is recommended. 
Replace the Raised Toilet Seat if any of these conditions exist.

L

There will be an audible “click”. Ensure the snap buttons fully protrude through the holes in the 
mounting tubes.

L

DO NOT use an abrasive detergent, cleaner or cloth to clean or dry the Raised Toilet Seat.

Inner Ring

Tall end of 

Raised Toilet 

Seat

Raised Toilet 

Seat (installed)

Raised Toilet 

Seat (installed)

Adjustment 

Knob

Rear Seat Wing

1-3/4 inch 

Toilet Lip

Adjustment 

Knob