Black Box AC1120A User Manual

 

 

 

 - -  - - - Alternate Response - - - - -

 

IP commands not enabled. Please refer to the manual 
This message indicates that IP setting through the RS-232 port is disabled on 
your unit for some reason. Please refer to section 3.2.12.2 below to enable this 
mode 
 

2. 

To get the current IP address of the matrix box:

 

Command: 

GIP <cr> stands for Get IP address. 

 

Response: 

192.168.123.180 

3. 

To set a new IP address:

 

Command: 

SIP192.168.123.179 <cr> stands for Set IP address. 

 

Response:   

OK .................................................. if command completed successfully. 
Error........................................................................... if command failed. 
 

4. 

To get the current gateway IP address:

 

Command: 

GGI <cr> stands for Get Gateway IP address. 

 

Response: 

192.168.123.122 

 

5. 

To set a new gateway IP address:

 

Command: 

SGI192.168.123.125 <cr> stands for Set Gateway IP address. 

 

Response: 

 

OK .................................................. if command completed successfully. 
Error........................................................................... if command failed. 
 

6. 

To get the current subnet mask:

 

Command: 

GNM <cr> stands for Get Net Mask. 

 

Response: 

255.255.255.0 

 

7. 

To set a subnet mask:

 

Command: 

SNM255.255.255.0 <cr> stands for Set Net Mask. 

 

Response:  

OK .................................................. if command completed successfully. 
Error........................................................................... if command failed. 
 

8. 

To get the current port number (this is the port to access the matrix):

 

Command: 

GPN <cr> stands for Get Port Number. 

 

Response: 

1001