3com DUA1800-0AAA04 User Manual

C

HAPTER

 2: I

NSTALLING

 T

HE

 L

INK

B

UILDER

 MSH

DUA1800-0AAA04

There are two sets of holes on each side of the MSH chassis. 
These allow for fitting the mounting brackets to two different 
positions:

■

If you decide to have the face of the chassis that takes the cable 
connections and shows module LEDs as the front, fit the brackets 
to the holes near this face.

■

If you decide to have the face of the chassis that is clear of 
connections as the front, fit the brackets using the set of holes 
towards the rear face. 

1 Match the appropriate bracket with the holes on the side face of 

the MSH chassis.

2 Locate the four slotted screws into the holes and tighten using a 

flat-tipped screwdriver.

To remove the bracket, loosen the four screws, and lift it away. 
Store both brackets and screws safely for future use.

1 Fit the mounting brackets that are supplied with the chassis to the 

face which you have decided is the front of the chassis.

2 Refer to the manufacturer's documentation that accompanies the 

19 inch rack for details of installation. If there is a door fitted to 
the rack, it is essential that there is adequate clearance between 
the door and the front of the MSH chassis to prevent damage to 
cables and connectors.

Chassis.bk : CHAPTER2  Page 4  Monday, February 10, 1997  1:11 PM