Panasonic AJ-HPM110E User Manual

Using USB Connectors and SD/SDHC Memory Cards: External Remote Control

113

U
s

ing
USB

Con

nec

tor
s

d S

/SD

HC Me

mor

C
a

External Remote Control

Use the RS-422A or IEEE1394 interface to send commands to

an external device to control it.

The following functions permit remote control.

• PLAY, STOP, STILL, FF, REW, SHTL, JOG

• Counter and status LED indication

Perform either of the following steps when the

THUMBNAIL and PLAY LIST buttons are off.

• In the RS-422 interface, press the EVENT button.

• In the IEEE1394 interface, hold down the SHIFT button

and press the EVENT button.

• This allows the unit to perform remote control of external

devices.

◆ NOTE:

• Select 59.94, 50, 23.98, 24, 29.97 or 25 in setup menu No. 25

SYSTEM FREQ when using RS-422A.

• Select 59.94 or 50 in setup menu No. 25 SYSTEM FREQ when using

IEEE1394.

• In AVC-Intra50

and AVC-Intra100

formats, IEEE1394 input and

output are not available.

• Complete any settings required for controlling a remotely connected

device before pressing the EVENT button.

*1 Available when the optional AVC-Intra Codec board AJ-YBX200G

is installed

In external control mode, the EVENT lamp goes on and the

unit provides the following indications.

• The LED goes on to indicate external device status.

• Indicates the external device counter

• The unit is forcibly set to EE to enable reception of audio

and video from the external device

• Counter, status and P mark indications for the external

device are superimposed on the screen.

◆ NOTE:

When 1394 input is selected and the unit is in STILL mode, it goes into

EE mode after engaging STOP mode.

The control buttons listed below enable remote control of an

external device.

*1 Available only when using RS-422A

Remote operation of external devices

Setup Procedure

Indications during control of external
devices

Remote operation procedure

STOP

Sends the STOP command.

PLAY

Sends the PLAY command.

STILL

Sends the STILL +0.0 command

REW

Sends the REW command.

Sends the FF command.

Dial

Sends the SHTL or JOG command.

COUNTER

Sends the switch COUNTER command

(CTL/TC only).

RESET

Sends the 0 reset command in CTL mode.