Panasonic AJ-HPM110E User Manual

Using USB Connectors and SD/SDHC Memory Cards: External Remote Control

Registering IN and OUT points makes possible automatic 

recording (AUTO CAPTURE) between those two points. 

Enter the mode that permits control of external 

devices.

Press the EVENT button when the THUMBNAIL and PLAY 

LIST buttons are off.

Select an area for capture. 

• Use the following buttons to select an area for capture. 

Hold down the SHIFT button and press the REC 

button.

• The specified area is automatically registered on the 

card.

• The EVENT button flashes during operation.

• The current point is registered as an IN point if an IN point 

has not been registered.

• Recording stops automatically when the OUT point is 

reached.

If an OUT point has not been registered, recording 

continues until the STOP button is pressed.

Audio and video played back from the current location can be 

recorded to a card. 

Enter the mode that permits control of external 

devices. 

 Hold down the SHIFT button and press the EVENT button 

when the THUMBNAIL and PLAY LIST buttons are off. 

Select the start of a section you want to capture. 

• Use the PLAY, STILL or other buttons to locate the start 

of the section you want to capture. 

Hold down the SHIFT button and press the REC 

button. 

• Start playback on the external device to start recording. 

• To end recording, press the STOP button. 

◆ NOTE:

• The accuracy of recording start varies with the connected external 

device.

Automatic Recording of Cards

Using the RS-422A interface

IN+ENTRY

Registers IN points

IN+RESET

Deletes IN points

OUT+ENTRY Registers OUT points

OUT+RESET Deletes OUT points

IN+GOTO

Sends a CUE-UP command to move to an 

IN point

OUT+GOTO

Sends a CUE-UP command to move to an 

OUT point

IN

Checks an IN point (counter indication)

OUT

Checks an OUT point (counter indication)

IN+OUT

Checks a DUR (counter indication)

Using the IEEE1394 interface