Linksys DES-3028/DES-3028P/DES-3052/DES-3052P User Manual
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
25
T
RAFFIC
S
EGMENTATION
C
OMMANDS
Traffic segmentation allows users to further sub-divide VLANs into smaller groups of ports that will help to reduce traffic on the
VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied.
VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied.
Command Parameters
config traffic_segmentation
[<portlist>] forward_list [null | <portlist>]
show traffic_segmentation
<portlist>
Each command is listed, in detail, in the following sections.
config traffic_segmentation
Purpose
Used to configure traffic segmentation on the Switch.
Syntax
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
<portlist>]
Description The
config traffic_segmentation command is used to configure
traffic segmentation on the Switch.
Parameters
<portlist>
− Specifies a port or range of ports that will be configured
for traffic segmentation.
forward_list
forward_list
− Specifies a range of ports that will receive forwarded
frames from the ports specified in the portlist, above.
Restrictions Only
administrator-level users can issue this command.
null
− No ports are specified
•
•
•
<portlist>
− Specifies a range of ports for the forwarding
list. This list must be on the same Switch previously
specified for traffic segmentation (i.e. following the
<portlist> specified above for config
traffic_segmentation).
specified for traffic segmentation (i.e. following the
<portlist> specified above for config
traffic_segmentation).
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3028P:4# config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3028P:4#
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3028P:4#
show traffic_segmentation
Purpose
Used to display the current traffic segmentation configuration on the
Switch.
Switch.
Syntax
show traffic_segmentation <portlist>
Description The
show traffic_segmentation command is used to display the
current traffic segmentation configuration on the Switch.
Parameters
<portlist>
− Specifies a port or range of ports for which the current
traffic segmentation configuration on the Switch will be displayed.
Restrictions
The port lists for segmentation and the forward list must be on the
same Switch.
same Switch.
168