Panasonic AJ-HPM100P User Manual

Introduction: Control Reference Guide

SD/SDHC Memory Card Slot

Insert an SD/SDHC memory card.

Insert the card with the label side facing up and the

end with the corner cut off facing in. Push in the card

until it locks into place. To remove the card, first make

sure that the lamp is not on, then push it in the direction

of insertion to release the lock.

◆ NOTE:

• Do not insert any cards other than SD/SDHC memory

cards.

• This unit uses only SD/SDHC memory cards that comply

with the SD/SDHC specifications. Other memory cards

such as MultiMediaCard cannot be used. When using a

miniSD card, be sure to use an adaptor dedicated for use

with the miniSD card to insert the card into the SD Memory

Card Slot.

* MultiMediaCard (MMC) is a registered trademark of

Infineon Technologies AG.

* The SDHC (SD High Capacity) card is a new standard,

established by the SD Card Association in 2006, for

large-scale memory cards with capacities above 2 GB.

• To format an SD card on a PC, use the following software

that can be downloaded from the support sites listed

below.

• This unit supports the following SD and SDHC memory

card capacities.

SD (8 MB to 2 GB): 8 MB, 16 MB, 32 MB, 64 MB, 128 MB,

256 MB, 512 MB, 1 GB, 2 GB

SDHC (4 GB only): 4GB

• For the latest information not available in the Operating

Instructions, visit the P2 support desk at the following Web

sites.

For English: https://eww.pavc.panasonic.co.jp/pro-av/

• The term “SD memory card” will be used below as a

generic for SD and SDHC memory cards.

USB 2.0 connector (Type A)

Connect P2 store and USB 2.0 compliant hard disk

drives for use in the USB host mode.

USB 2.0 connector (Type B)

Connect personal computers and other devices for

use in the USB device mode.

◆ NOTE:

• Use double shielded cable for making connections to USB

2.0 connectors.

Side Panel