Panasonic AJ-HPM100P User Manual

Page of 152
54
Clip Management: Attaching Metadata to Clips
■ Incrementing the COUNT value of the USER 
CLIP NAME for clips exceeding 4 GB
In the following case, one shot is recorded as multiple clips 
and the COUNT value is automatically incremented and 
recorded for each shot. 
• When an 8 GB or larger P2 card is used in this unit and each 
continuous recording exceeds a preset time. 
• When one recording spans multiple cards. 
A P2 device will indicate the thumbnail and COUNT value of 
clip 1 when thumbnails and property of the clip are displayed. 
Use the following procedure to load metadata from an SD 
memory card. 
1
Insert the SD memory card storing the metadata 
upload file.
2
Open the thumbnail screen. 
3
Press the MENU button. 
4
Use the cursor buttons to select [META DATA] – 
[LOAD] and press the SET button.
The filename of the metadata upload file on the SD 
memory card appears. 
◆ NOTE:
• When the file name is displayed, use the right cursor button to 
show the metadata name. Use the left cursor button to show the 
file name. 
5
Use the cursor buttons to select the file to load and 
press the SET button.
6
Select [YES] and press the SET button.
The file is now loaded. 
7
Press the MENU button to end processing. 
Use the following steps to check metadata loaded from an SD 
memory card. 
1
Press the THUMBNAIL button. 
The thumbnail screen appears on the LCD monitor. 
2
Press the thumbnail menu button and select [META 
DATA] – [PROPERTY] from the Thumbnail menu. 
The screen shown below appears. 
Loading Set Metadata Values
Example of a recording on one P2 card (DVCPRO HD):
Example of recording a clip on two P2 cards:
REC start 
(start of recording)
Stop 
(recording stop)
REC start 
(start of recording)
Stop 
(recording stop)
Recording duration = 6 minutes
Clip 1
COUNT value = A
Clip 2
COUNT value = A + 1
Approx. 5 min.
Approx. 1 min.
Clip 1 
COUNT value = A
Clip 2
COUNT value = A + 1
1st card
2nd card
Checking and Revising Loaded Metadata