Hitachi VT-FX602S User Manual
PRESET FOR USE
- 21 -
Press CH/SET
or
button repeatedly to point to "TV STEREO" or
"SAP.
Then, press SELECT button.
Then, press SELECT button.
VCR SET UP
TAPE
SELECT
~T130
REPEAT
PLAY
RENTAL
AUTO
AUTO
RETURN
AUDIO
OUT
TV STEREO
[ON]
SAP
4 To return to TV mode
Press MENU button.
Press MENU button.
Notes:
• You must select the recording mode in TV STEREO or SAP when you record
broadcast.
Refer to "MTS RECORDING/MONITOR MODE" on previous page.
When you play the tape on the VCR later, it will be in stereo or second audio.
• If you select second audio when second audio is not available, the VCR will
record normal audio.
• You must select the recording mode in TV STEREO or SAP when you record
broadcast.
Refer to "MTS RECORDING/MONITOR MODE" on previous page.
When you play the tape on the VCR later, it will be in stereo or second audio.
• If you select second audio when second audio is not available, the VCR will
record normal audio.
PRESET FOR USE
Channel memory programming is NOT needed when connected to a cable
box. You can program the tuner to scan only the channels you receive in
your area. See page 38 for channel designations.
box. You can program the tuner to scan only the channels you receive in
your area. See page 38 for channel designations.
NOTE: You must use the remote control for this procedure.
AUTOMATIC CHANNEL PRESET (Without a Cable Box)
NOTES:
• Follow the steps below once. Repeat it only if there is a power failure or the
VCR is unplugged for more than 30 seconds. (In these cases, the programmed
channels are erased.)
• You must follow the steps below before attempting to play or record a video
tape. If you want to play or record a video tape BEFORE programming the tuner,
you must first press the POWER button to turn off the VCR. Then, press the
POWER button again to turn it back on. To program the tuner again, see
"CHANNEL PRESET AGAIN".
• Follow the steps below once. Repeat it only if there is a power failure or the
VCR is unplugged for more than 30 seconds. (In these cases, the programmed
channels are erased.)
• You must follow the steps below before attempting to play or record a video
tape. If you want to play or record a video tape BEFORE programming the tuner,
you must first press the POWER button to turn off the VCR. Then, press the
POWER button again to turn it back on. To program the tuner again, see
"CHANNEL PRESET AGAIN".