Sony ICDTX50 User Manual

Page of 121
ModelName: ICD‑TX50
PartNumber: 4‑300‑042‑11(1)
11 
11 
Troubleshooting
Continued 
Messages List
Follow the instructions below if a message appears in the display.
Message
Cause/Remedy
HOLD...
Slide HOLD Switch to 
Activate.
 All the button operations are disabled because the IC 
recorder is in the HOLD status to prevent unintentional 
operations. Slide the POWER•HOLD switch towards the 
center to release the IC recorder from the HOLD status 
( p. 16).
Low Battery Level
 You cannot format the memory or erase all the files in a 
folder because of insufficient battery power. Charge the 
battery ( p. 18). 
Low Battery
 The battery is exhausted. Charge the battery ( p. 18). 
Low Battery to Update
 You cannot update the firmware because of insufficient 
battery power. Charge the battery ( p. 18).
microSD Card Error
 An error occurred while a microSD card was being inserted 
into the microSD card slot. Remove and try inserting it 
again. If this message persists, use a new microSD card.
microSD Card Not 
Supported
 A microSD card that the IC recorder does not support is 
Read Only microSD Card  A read‑only microSD card is inserted. A read‑only 
microSD card cannot be used with the IC recorder.
microSD Card Locked
 A write‑protected microSD card is inserted. Release the 
lock.
Memory Full
 The remaining memory capacity of the IC recorder is 
insufficient. Erase some files before recording.
File Full
 When there are already the maximum number of files in 
the selected folder or the total number of files stored on the 
IC recorder has exceeded the maximum, you cannot record 
a new file. Erase some files before recording.
Settings are Full
 You cannot rename a folder, since folders with the same 
folder name already exist. Please select a different folder 
name.
Track Marks are Full
 You cannot set a track mark, since there are already the 
maximum number of track marks for a file. Cancel 
unwanted track marks ( p. 61).
File Damaged
 You cannot play back or edit files, because the data of the 
selected file is damaged.