Sony NW-A808 User Manual
NW-A805/A806/A808/NWZ-A815/A816/A818
9
3-5. NAND BOARD, SVX SWITCH FLEXIBLE (PWB ASSY)
3-6. NOTE WHEN INSTALLING THE SVX SWITCH FLEXIBLE (PWB ASSY)
Note:
Follow the assembly procedure in the numerical order given.
4
Turn up the LCD flexible board.
1
two claws
2
Lift up the
SVX swtch flexible (PWB assy).
SVX swtch flexible (PWB assy).
5
Lift up the NAND board.
3
two screws (M1.4)
9
sheet (NAND)
qa
NAND board
q;
spacer (NAND)
6
Remove three solders.
8
SVX swtch flexible (PWB assy)
7
insulating sheet
(NW-A805/A806/
NWZ-A815/A816 only)
NWZ-A815/A816 only)
– rear view –
2
Holding the bent part,
rotate the SVX swtch flexible (PWB assy)
by 3 or 4 turns in the arrow direction,
and twist to bind the lead wires.
rotate the SVX swtch flexible (PWB assy)
by 3 or 4 turns in the arrow direction,
and twist to bind the lead wires.
About 45
°
1
Bend the switch flexible board.
4
Push the lead wires completely into a space
between front cabinet assy and LCD holder.
between front cabinet assy and LCD holder.
3
Holding the bent part, push in the
SVX swtch flexible (PWB assy)
until it gets stuck by two claws
of the front cabinet assy.
SVX swtch flexible (PWB assy)
until it gets stuck by two claws
of the front cabinet assy.
Note: Route the lead wires as shown in the figure,
and solder them at the angle shown in the figure.
Note: The soldering height
should be less than 0.8 mm.
About 45
°
SVX swtch flexible (PWB assy)
NAND board
lead wire (red)
lead wire (gray)
lead wires
front cabinet assy
claw
lead wire (black)
claw
LCD holder
– rear view –