JVC BR-DV6000U User Manual

42

 Settings of the AUDIO menu (

☞

● AUDIO MODE

This is for selecting the audio sampling fre-
quency for recording.
32 K: Recording in the 32 kHz mode. Select

32 K when performing audio dubbing on
CH3 and CH4.

48 K: Recording in the 48 kHz mode. Audio dub-

bing is not available.

● AUDIO INPUT SEL (Displayed only when

an optional board is installed)
This setting is required with XLR IN board SA-
X61U (sold separately) installed.  Set this item
to XLR for selecting the audio input terminal of
the XLR IN board.

 Setting the SYSTEM Menu (

☞

● LONG PAUSE TIME

This is for setting the time for BR-DV6000 to
enter the tape protection mode if there is a long
recording pause.

● INDEX WRITE: SYSTEM (2/2) Menu

This is for selecting whether to record index sig-
nals automatically when recording starts.

● PB/DV IN: SYSTEM (2/2) Menu

For recording NTSC signals, set this item to
NTSC.
For recording PAL signals from the DV termi-
nal, set this item to PAL.

 Setting the time code recording for DV

Select data from the built-in time code genera-
tor or from the DV terminal with TC DUPLICATE
in the TC/UB/CLOCK (1/2)  Menu screen.
(

☞

 Page 80)

 Setting date/time recording

Perform setting for the following items.
• Set DATE REC in the TC/UB/CLOCK (2/2)

Menu screen to ON.

• Set DISPLAY in the DISPLAY (1/2) Menu

screen to ON.

• Set TIME/DATE in the DISPLAY (2/2) Menu

screen to any setting item except OFF.

The same data as on the date/time on-screen
display are added to the image and recorded.

INPUT SELECT switch

 Selecting input signal

Select the signal with the INPUT SELECT switch
located on the front panel.
DV

: For inputting DV signals (video and

audio)

: For inputting composite video and

analog sound signals

Y/C (CPN) : For inputting Y/C separate signals

or component signals for video. The
type of signal to input can be se-
lected with VIDEO INPUT SEL of
the VIDEO Menu.
For sound, analog signals are in-
put.

● For analog audio signals, if the AUDIO IN

terminal and MIC terminal are used at the
same time, the MIC terminal precedes.

● Audio signals are recorded on CH1 and CH2.
● Analog signals cannot be recorded when PB/

DV IN is set to PAL.
In such a case, recording is not possible.

● For DV signal input, the AUDIO MODE set-

ting cannot be performed.
It will be the same mode as that of the input
signal (48 K or 32 K).

With DV signal input, data of the built-in clock
are not recorded.
If video signals are input from the DV terminal,
the date/time data from this terminal are re-
corded regardless of the menu settings.

 Settings the VIDEO Menu (

☞

● SET UP (only for NTSC)

Set here according to the existence of the setup
of analog video signals (composite, YC sepa-
rate and component). If it exists, set here to ON.
If it does not, OFF.

● BLACK BURST

Set BLACK BURST to ON to record the black
burst signals (black screen) of the built-in sig-
nal generator.
(When analog input is selected)

DV6000U_28-051_Eng.p65e

03/04/03, 3:07 PM

42