JVC DR-MV5S User Manual
Filename [MV5S_05Name.fm]
Masterpage:Left0
16
EN
Page 16
Wednesday, 2 March 2005 14:23
GET OVER IT! – CONNECTION –
It’s essential that your unit be properly connected.
Connect the unit to a TV depending on the TV and cables
you use.
you use.
Composite Connection (Without Cable Box Or DBS
Receiver)
Receiver)
1
Disconnect the antenna from the TV.
2
Connect the antenna to the [VHF/UHF IN] connector
on the rear panel of the unit.
on the rear panel of the unit.
3
Connect the supplied RF cable between the [VHF/
UHF OUT] connector on the rear panel of the unit
and the TV’s antenna terminal.
UHF OUT] connector on the rear panel of the unit
and the TV’s antenna terminal.
4
Connect the supplied audio/video cable between the
[VIDEO/AUDIO OUTPUT (DVD/VCR)] connectors
on the unit and the TV’s audio/video input
connectors.
[VIDEO/AUDIO OUTPUT (DVD/VCR)] connectors
on the unit and the TV’s audio/video input
connectors.
5
Plug the end of the AC power cord into an AC outlet.
This unit performs Plug & Play Set automatically.
(
This unit performs Plug & Play Set automatically.
(
● The clock and tuner channels will automatically be set when the
antenna is connected and when the AC power cord is first
connected to an AC outlet. (If “AUTO” and the channel indicator
are displayed on the front display panel before the unit is
powered on, the clock and tuner channels are being set
automatically. Wait for the time to be displayed on the front
display panel before turning on the unit.)
connected to an AC outlet. (If “AUTO” and the channel indicator
are displayed on the front display panel before the unit is
powered on, the clock and tuner channels are being set
automatically. Wait for the time to be displayed on the front
display panel before turning on the unit.)
● “LOADING” blinks on the front display panel when the AC plug of
the AC power cord is connected into an AC outlet and it takes
approximately 50 seconds for the unit to be turned on. This is not
a malfunction.
approximately 50 seconds for the unit to be turned on. This is not
a malfunction.
NOTE:
You cannot view images received by this unit on channel 3 or 4.
Connections
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO
OPERATION CAN BE PERFORMED.
OPERATION CAN BE PERFORMED.
Antenna or Cable
Matching transformer
(not supplied)
(not supplied)
Coaxial cable
AC outlet
Back of unit
Flat feeder
TV
AC power cord
To 75 ohm
terminal
terminal
Audio/video cable
(supplied)
RF cable (not supplied)
To [VIDEO/
AUDIO
OUTPUT
(DVD/VCR)]
RF cable
(supplied)
(supplied)
To audio/
video input
connectors
To component video
input connectors
To [VHF/
UHF OUT]
UHF OUT]
To [VHF/UHF
IN]
MV5S_00.book Page 16 Wednesday, March 2, 2005 2:26 PM