Panasonic SC-HT1500 User Manual

4

RQT7619

Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions 
listed below. Keep these operating instructions handy for future reference.

1)

Read these instructions.

2)

Keep these instructions.

3)

Heed all warnings.

4)

Follow all instructions.

5)

Do not use this apparatus near water.

6)

Clean only with dry cloth.

7)

Do not block any ventilation openings. Install in accordance with 
the manufacturer’s instructions.

8)

Do not install near any heat sources such as radiators, heat 
registers, stoves, or other apparatus (including amplifiers) that 
produce heat.

9)

Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than 
the other. A grounding-type plug has two blades and a third 
grounding prong. The wide blade or the third prong are 
provided for your safety. If the provided plug does not fit into 
your outlet, consult an electrician for replacement of the 
obsolete outlet.

10) Protect the power cord from being walked on or pinched 

particularly at plugs, convenience receptacles, and the point 
where they exit from the apparatus.

11) Only use attachments/accessories specified by the 

manufacturer.

12) Use only with the cart, stand, tripod, bracket, or 

table specified by the manufacturer, or sold with 
the apparatus. When a cart is used, use caution 
when moving the cart/apparatus combination to 
avoid injury from tip-over.

13) Unplug this apparatus during lightning storms or 

when unused for long periods of time.

14) Refer all servicing to qualified service personnel. Servicing is 

required when the apparatus has been damaged in any way, 
such as power-supply cord or plug is damaged, liquid has been 
spilled or objects have fallen into the apparatus, the apparatus 
has been exposed to rain or moisture, does not operate 
normally, or has been dropped.

This reminder is provided to call the CATV system installer’s 
attention to Article 820-40 of the NEC that provides guidelines for 
proper grounding and, in particular, specifies that the cable ground 
shall be connected to the grounding system of the building, as 
close to the point of cable entry as practical.

The lightning flash with arrowhead symbol, within 
an equilateral triangle, is intended to alert the user 
to the presence of uninsulated “dangerous voltage” 
within the product’s enclosure that may be of suffi-
cient magnitude to constitute a risk of electric shock 
to persons.

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

The exclamation point within an equilateral triangle 
is intended to alert the user to the presence of 
important operating and maintenance (servicing) 
instructions in the literature accompanying the ap-
pliance.

This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This 
equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference 
will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or more of 
the following measures:
≥Reorient or relocate the receiving antenna.
≥Increase the separation between the equipment and receiver.
≥Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected.

≥Consult the dealer or an experienced radio/TV technician for 

help.

FCC Caution: To assure continued compliance, follow the 
attached installation instructions and use only shielded interface 
cables when connecting to peripheral devices.
Any changes or modifications not expressly approved by the party 
responsible for compliance could void the user’s authority to 
operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: (1) This device may not 
cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause 
undesired operation.