Panasonic AJ-SD255 User Manual

Page of 46
8
Parts and their functions
Front panel
Digital Video Cassette Recorder AJ-
SUPER
ON
OFF
TCG
REGEN
PRESET
EXT
INT
COUNTER
PF
PF1
PF2
PF3
DIAG
MENU
PUSH
SHTL/SLOW
TC 
PRESET
METER
FULL/FINE
MONITOR SEL
RESET
UNITY VAR
INPUT SELECT
VIDEO
AUDIO
CH 1
CH 2
CH 1
CH 2
REC
PB
HEADPHONES
SEARCH
EJECT
POWER
REC INHIBIT
CONTROL
ON
ON
OFF
OFF
LOCAL
REMOTE
REC
PLAY
FF
REW
STOP
POWER switch
Cassette insertion slot
EJECT button
When this button is pressed, the tape is unloaded and the
cassette is ejected automatically a few seconds later.
When CTL display has been selected for the counter
display, the display is reset.
EJECT button operation can be enabled or disabled with
setup menu No. 115 (EJECT SW INH).
CONTROL switch
This is selected to control the unit from an external
source using the REMOTE connector.
REMOTE: Set to this position to control the unit using the
9-pin REMOTE connector and IEEE1394
AV/C commands.
LOCAL   : Set to this position to control the unit using the
controls on the unit's operation panel.
REC INHIBIT switch
This switch is used to enable or disable recording on the
cassette tape.
ON:
Recording on the cassette tape is disabled 
(inhibited).
In this state, the REC INH lamp lights on the display
panel.
OFF:
Recording on the cassette tape is enabled so long
as the accidental erasure prevention mechanism on
the cassette tape is set to enable recording.
METER (FULL/FINE) selector button 
This button is used to select the scale display for the
audio level meter.
FULL mode
The standard scale (– 
∞ to 0 dB) is
selected.
FINE mode
The scale in 0.5 dB increments is
selected. The 
position indicates the
standard level of –20 dB (–18 dB). (See
page 11)
MONITOR SEL button
This button is used to select the audio signals which are
to be output to the AUDIO MON L and R connectors.
Each time the button is pressed, the audio signals to be
output to the AUDIO MON L or R connector are changed
in the following sequence.
Which signal is currently selected is displayed by the
lighting of the L or R lamp on the level meter display.
Headphone jack and volume control
When stereo headphones are connected to the
headphone jack, the sound can be monitored using the
headphones during recording or playback.
Audio level control knobs
These knobs are used to adjust the recording and
playback level of the PCM audio signals (CH1 and CH2).
The audio level control selector switch 
is used to set
to variable or fixed level.
Note:
The level of the IEEE1394 digital input/output audio
signals cannot be adjusted.
Audio level control selector switch
UNITY: At this position, the audio signals are recorded or
played back at a fixed level regardless of the
position of the audio level control knobs 
.
VAR: At this position, the audio signals are recorded or
played back at the level adjusted by the audio level
control knobs 
.
Note:
When UNITY is selected, the recording and playback
levels both become UNITY (fixed level).
L : 
  [CH1]      [CH1]      [CH2]      [CH1+CH2]
R :   [CH2]      [CH1]      [CH2]      [CH1+CH2]
→