DELL SCv2080 User Manual

Before You Begin

Consider the following best practices before setting up your SCv2080 storage system.

• Dell recommends that you use a dedicated SAN network for data transmission when using a Fibre

Channel or iSCSI storage system.

• Complete the Worksheet to Record System Information in this guide before configuring the storage

system.

• Always configure redundant data paths to provide alternate paths to and from the host server should

one of the data paths become disabled.

• Before connecting any cables between the storage system and host server or expansion enclosure,

physically label each port and connector.

• Always follow proper power-up and power-down procedures when cycling power across the

network. Verify that critical network components are on separate power circuits.

NOTE: This product is intended for restricted access locations, such as a dedicated equipment
room or equipment closet.

WARNING: If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient temperature. Therefore,
consideration should be given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specified by the manufacturer.

Safety Warnings

A fully configured SCv2080 storage system weighs up to 130 kg
(287 lb). An unpopulated storage system weighs 62 kg (137 lb). Use
appropriate lifting methods when installing the storage system.

The operating temperature inside the drawers of a storage system
can reach up to 60°C (140°F). Take care when opening drawers and
removing disk carriers.

Disconnect all electrical supply connections to the storage system
before proceeding.

CAUTION: Remove the battery pack before removing a
storage controller from the storage system.