Martin Audio Portable Speaker User Manual
1
Powering your OmniLine
tm
(For general system preparation, see the OmniLine
system preparation - preliminary guidance)
General
Your OmniLine
tm
is delivered in blocks of 4 modules ready wired in parallel. These four-module blocks
may be separated into smaller blocks or individual modules, linked and paralleled to other blocks or
modules using short link wires - or series connected to other blocks or modules using the series
Connector pcb supplied with each four-module block (see illustration below).
modules using short link wires - or series connected to other blocks or modules using the series
Connector pcb supplied with each four-module block (see illustration below).
The Connector pcb also provides an input termination.
This allows the installer to build an array of appropriate length (we recommend 6% of each plane to
be covered for good spectral balance) with electrical characteristics best suited to the Martin Audio
power amplifier chosen.
be covered for good spectral balance) with electrical characteristics best suited to the Martin Audio
power amplifier chosen.