Insignia NS-RAD01-C User Manual

Quick Setup Guide  |  

NS-RAD01-C

• Radio  

   

•  Wrist Strap 

• Earphone     

• Quick Setup Guide

Tuning LED

FM antenna
Wrist strap hole

Tuning dial

Volume

 switch

Band

 switch

Power ON/OFF

Battery door

Tuning display bar

Speaker

Earphone jack

Wrist strap hole

1  Open the battery compartment door located at the 

back of your radio.

2  Insert two AAA batteries into the battery 

compartment. Make sure the + and - on the batteries 
match the + and - inside the battery compartment

3  Replace the battery door.

The radio will not work when the batteries are low. If 
this occurs, replace the batteries.
•  Danger of explosion if batteries are incorrectly replaced. 

Replace only with the same or equivalent type.

•  Use only the size and type of battery specified.
•  Be sure to follow the correct polarity when installing 

the batteries as indicated in the battery 
compartment. A reversed battery may cause damage 
to the device.

•  Do not mix different types of batteries together 

(e.g., Alkaline, Rechargeable, and Carbon-zinc) or old 
batteries with fresh ones.

•  If the radio is not to be used for a long period of time, 

remove the batteries to prevent damage or injury 
from possible battery leakage.

•  Do not try to recharge a battery not intended to be 

recharged; it can overheat and rupture. (Follow the 
battery manufacturer’s directions.)

•   Exhausted batteries must be removed to prevent any 

battery leakage.