Sony CDX-M60UI Manual

Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)

Power requirements: 12 V DC boat battery

(negative ground (earth))

Dimensions: Approx. 178

× 50 × 182 mm

× 2 × 7

in) (w/h/d)

Mounting dimensions: Approx. 182

× 53 × 162 mm

× 2

× 6

in) (w/h/d)

Mass: Approx. 1.3 kg (2 lb 14 oz)
Supplied accessory:

Card remote commander: RM-X151
Parts for installation and connections (1 set)

Optional accessories/equipment*:

Marine remote commander: RM-X60M,
RM-X11M
Rotary commander: RM-X4S
BUS cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
Source selector: XA-C40
AUX-IN selector: XA-300
USB connection cable for iPod: RC-100IP
HD Radio™ tuner: XT-100HD

* Accessories/equipment other than the marine

remote commander RM-X60M/X11M are not
waterproof. Do not subject them to water.

Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.

Design and specifications are subject to change
without notice.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.

If the problem is not solved, visit the following
support site.

• Halogenated flame retardants are not used in the

certain printed wiring boards.

• Halogenated flame retardants are not used in

cabinets.

• Packaging cushions are made from paper.

General

No power is being supplied to the unit.

• Check the connection or fuse.
• If the unit is turned off and the display disappears, it

cannot be operated with the remote commander.

t Turn on the unit.

The power antenna (aerial) does not extend.

The power antenna (aerial) does not have a relay box.

No sound.

• The ATT function is activated, or the Telephone ATT

function (when the interface cable of a telephone is
connected to the ATT lead) is activated.

• The position of the fader control “FAD” is not set for

a 2-speaker system.

No beep sound.

• The beep sound is canceled (page 17).
• An optional power amplifier is connected and you are

not using the built-in amplifier.

The contents of the memory have been erased.

• The RESET button has been pressed.

t Store again into the memory.

• The power supply lead or battery has been

disconnected or it is not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.

The leads are not matched correctly with the boat’s
accessory power connector.

continue to next page

Support site

For customers in the U.S.A. and Canada:

http://esupport.sony.com
http://www.xplodsony.com/

For customers in Europe:

http://support.sony-europe.com

For customers in Latin America:

http://esupport.sony.com/ES/LA/

For customers in Pan Asia:

http://www.sony-asia.com/section/support
http://www.sony-asia.com/caraudio/