Sharp DK-KP85PH User Manual

EN

To mount the unit on the wall

 

●

Be very careful to prevent the unit [2.45 kg (5.4 lbs.)] 

from falling when mounting on the wall.

 

●

Before  mounting,  check  the  wall  strength.  (Do  not 

put  on  the  veneer  plaster  or  whitewashed  wall. The 

unit  may  fall.)  If  unsure,  consult  a  qualified  service 

technician.

 

●

Mounting  screws  are  not  supplied.  Use  appropriate 

ones.

 

●

Check all wall mount screws for looseness.

 

●

Select a good location. If not, accidents may occur or 

the unit may get damaged.

●

■

SHARP designed the unit so you may hang it on the wall. 

Use proper screws (not supplied). See below for size and 

type.

3.2 mm (1/8”)

9 mm (3/8”)

Min. 22 mm (7/8”)

5 mm 

(3/16”)

■

Fix  the  pattern  paper  to  the  wall  in  horizontal 

position as below.

29 mm

44 mm

44 mm

509 mm

Wall surface

Pattern paper (supplied)

188 mm

Make a hole on the wall following the screw point 

marks on the pattern paper by using a drill.

Wall surface

32 mm (1-1/4”)

8-9 mm (3/8”)

Fix a wall mount plug into the hole using a hammer, 

until it is flush with the wall surface.

32 mm (1-1/4”)

8-9 mm (3/8”)

Wall surface

Fasten  the  screws  to  the  wall  as  shown  below.  

(Total screw is 2 pieces).

Wall surface

Wall surface

4.3 ~ 4.8 mm

Gap from the wall surface

Hang the unit onto the screws.

Wall surface

■

Safety wires (not supplied) are useful to prevent the unit 

from falling off the wall.

Wall

Screw eye (not supplied)

Safety wires (not supplied)

Loop  the  safety  wires  (not  supplied)  into  each  hole  as 

shown and tie the safety wires to a hook (screw eye).

Ø wire > 1.5 mm

The diameter of wire/cable must be less than 1.5 mm.