Sharp DK-KP85PH User Manual
E-18
EN
Listening to the radio (continued)
■
Memorising a station
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in “Tuning”.
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to
store that station in memory. If the “MEM” and preset
number indicators disappear before the station is
memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
Note:
The backup function protects the memorised stations for
The backup function protects the memorised stations for
a few hours should there be a power failure or the AC
power lead becomes disconnected.
■
To recall a memorised station
Press the PRESET ( or ) button to select the desired
station.
■
To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1
Press and hold the PRESET ( or ). The preset
number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the
desired station is located.
■
To erase entire preset memory
1
Press the ON/STAND-BY button to turn the power
on.
2
Press the FUNCTION button (main unit) repeatedly
or TUNER button (remote control) to select Tuner
function.
3
In Tuner function, press and hold the CLEAR button
(remote control) until “Tuner Clear” appears.
Using the Radio Data System (RDS)
RDS is a broadcasting service which a growing
number of FM stations provide. These FM stations
send additional signals along with their regular
programme signals. They send their station names,
and information about the type of programme such as
sport, music, etc.
When tuned to an RDS station, “RDS” and the station
name will be displayed.
“TP” (Traffic Programme) will appear on the display when
the received broadcast carries traffic information, and
“TA” (Traffic Announcement) will appear while a traffic
information is on air.
“PTYI” (Dynamic PTY Indicator) will appear while the
Dynamic PTY station is received.
You can control the RDS by using the buttons on the
remote control only.
■
Information provided by RDS
Each time the RDS DISPLAY button is pressed, the
display will switch as follows:
BLUETOOTH
PAIRING
Station name (PS)
Programme type (PTY)
Radio text (RT)
Frequency
When tuning in to a station other than an RDS station or to
an RDS station which sends weak signal, the display will
change in the following order:
No PS
No PTY
FM 98.80 MHz
No RT