JVC XL-PG3S User Manual

p3

p4

p2

R

L

01

02 53

 

07

00 18

10

44 48

Skip function
During play,

Search function
Keep depressed during play.

• Play  stops  automatically

when  all  the  tracks  have
been played.

“dISC”
This indication appears if 

3/8 is pressed when no disc is loaded

or if the disc is not properly seated.

“–  –”
Preparation period before playing the track
Flashes for several seconds after pressing 

3/8 to play.

“OPEn”
This indication appears when the lid is open.

Turn off the unit and, after the disc has stopped rotating, remove
the disc as shown below:

If the unit is left in stop mode for 30 seconds, the unit turns
itself off automatically to prevent the batteries from running
down.

The portable CD player uses a power-saving operation method
so that disc rotation noise will intermittently be emitted. But, it
is not a failure.

• To  skip  back  to  the  previous  track,  quickly  press 

4

twice.

• During  Program  play,  the  button  is  used  to  fast  for-

ward  or  back  through  the  programmed  sequence  of
tracks.

• During  Random  play,  the  skip  button  cannot  be  used

to  skip  back  to  tracks  that  were  played  previously  in
the random sequence.

During play,

During play,

Total number of tracks

Total playing time.

Label side

Elapsed playing time of
each track

No indication

You can successively play the first 10 seconds of every track.

To cancel
Press MODE repeatedly until “INTRO” goes out.

• You can also select Intro play during playback.

In  this  case,  Intro  play  will  start  from  the  next  track  after  the
current track has finished.

• You can also select Intro play during Program play mode.

After playing all tracks, the unit stops.

To cancel
Press MODE until “RAND” goes out, or press 

7 to stop the disc.

• You can also select Random play in stop mode.
• During Program play, you can not select Random play.

You  can  program  up  to  32  tracks  in  any  desired  order  including
the same tracks.

00

01

03

01

00

02

The track is registered.

When  you  program  exceeding  32  tracks,  the  program  se-
quence number returns to “01” and will overwrite the previ-
ous setting.

While  stopped,  press  PROGRAM  repeatedly.  At  this  time,  you
can change the program, if required.

Turn off the unit.

Program  sequence
number

Track number to be programmed
00: Not programmed yet.

e.g. Track number 3

You can repeat one track or all tracks.

To cancel
Press MODE repeatedly until the repeat indicator goes out.

• You can also select Repeat play during Program play.
• You can also select Repeat play while stopped.

You can enjoy powerful bass sound.

This function achieves excellent performance against sound inter-
ruption  caused  by  vibrations.  You  will  be  able  to  enjoy  listening
to music during (not vigorous) jogging.
By utilizing the high-performance servo circuit, audio data will be
stored in the memory ahead of time (up to 45 seconds worth).
Normally, this function is in effect.

As the audio data is gradually stored, the indicator changes as follows:

The “ANTI SHOCK” indicator goes out.

To activate again
Press the ASP button.

• During this operation, the disc rotates at a higher rate than usual

in order to collect extra audio data. This may cause the batteries
to run out faster and could result in a slight increase in disc rota-
tion noise.

• This  function  can  be  switched  ON  and  OFF  during  playback.

However, this may cause a slight interruption in the sound be-
cause the disc’s rotational speed changes.

[Fully stored]

ANTI SHOCK

indicator

(Repeatedly)

Next program sequence number

(Repeatedly)

(Repeatedly)

Do not forcibly open the battery lid too wide.

This indicator appears when the batteries are almost out of power.
Power will be cut off a short while later.

Turning off the Anti-Shock Protection EX will save the battery power
more or less. For details, see “Anti-shock Protection EX” on page 4.

Battery indicator

AC adaptor

• Even if the unit is turned off, small power is consumed as long

as the AC adaptor is connected to the AC power outlet.

• When you want to purchase the AC adaptor, see page 5.

AC power outlet

• When the unit is in Hold mode, “HoLd” and “

” lights as

follows.
Power on : “

” stays lit.

Power off : “HoLd”  and  “

”  lights  up  for  a  few  seconds

when 

6 is pressed.

If the HOLD switch is set to the ON position, you cannot turn on
the unit.

This function causes the unit to ignore, accidental button presses.

• Powering on the unit accidentally (which can cause the batter-

ies to go dead).

• Play being cut off unexpectedly.

OFF

ON

HOLD

• To  prevent  the  unit  from  powering  on  accidentally,  set  the

HOLD switch to the ON position while the unit is turned off.

• To  prevent  the  unit  from  unexpected  operation  during  play,

set the HOLD switch to the ON position after you starts play-
ing the disc.

Two “LR6” alkaline batteries.

Track number in play

Firmly connect

While stopped,

Press again to restart play.

1 track repeat

All track repeat