Bose 4400 User Manual
13 of 66
3.0 Freespace
®
4400 Hardware Description
3.2 Rear panel
3.2.1 System controls
SENSE MICROPHONES – Input connectors for sensing
microphones used with the Auto Volume feature.
RS-232 – Standard RS-232 communications port. Provides
a communications interface for a PC running FreeSpace
®
4400
Installer™ software. The FreeSpace 4400 Installer™ software is
used to configure the FreeSpace 4400 system.
used to configure the FreeSpace 4400 system.
Note:
The RS-232 port should only be used to connect a
FreeSpace 4400 system to a PC.
WALL PLATE CONNECTIONS – Input connectors for AVM
1-Zone, AVM 2-Zone User Interface, or Page user interfaces.
REMOTE ON/OFF – An input connector for a remote
STANDBY switch.
3.2.2 Audio source inputs
LINE 1/LINE 2 – Unbalanced audio inputs
AUX MIC/LINE 3 – Balanced audio input with phantom power
PAGE/MIC/LINE 4 – Balanced audio input with phantom power
DIRECT IN/CONTROL – Balanced (DSP bypassed, full amplifier
gain) audio input which can override the sources playing on all
four output channels
gain) audio input which can override the sources playing on all
four output channels
3.2.3 Amplifier outputs
ZONE OUTPUTS 1/2/3/4 – Loudspeaker connections for
four zones
Installer’s Note: Please notice the polarity markings when
wiring loudspeaker cables to the ZONE OUTPUT connectors.
wiring loudspeaker cables to the ZONE OUTPUT connectors.
CAUTION: DO NOT ground the minus (–) terminals.
ZONE 4 LINE OUT – A line-level output that duplicates the
program material from LINE 4. May be used to feed another
amplifier installed for a large zone. The 12V control output is used
to connect to Bose
amplifier installed for a large zone. The 12V control output is used
to connect to Bose
®
amplifier sequence inputs.
MUSIC ON HOLD/PBX OUT – An audio output used to
provide music input to a PBX system
3.2.4 AC power
OUTPUT VOLTAGE – Sets the ZONE OUTPUT lines to 70/
100V.
POWER ON/OFF – Switches AC power on or off
Fuse –T6.3(6,3)A L 250V (100/120V) or
T3.15(3,15)A L 250V (220-240V).
AC MAINS LINE CORD JACK – AC line voltage input
INPUT VOLTAGE – switches need to be configured for
proper input voltage.
1
12
2
3
4
5
6
7
8
9
10
11
13
1
2
3
4
5
6
7
8
9
10
11
12
13