Timex T435 User Manual

Page of 10
Model T435
MP3/CD Line-In
dual alarm clock radio
Para instruccionese en Espanol, llame al 1-800-888-4491.
For questions or comments regarding this or other products,
p l e a s e   c a l l   o u r   t o l l - f re e   n u m b e r   1 - 8 0 0 - 8 8 8 - 4 4 9 1 .
For additional information, online registration,
and exclusive special offers visit our website:
www.timexaudio.com
Limited 90-Day Warranty Information
Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free
from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.
Should service be required by reason of any defect or malfunction during the warranty period, SDI Technologies will repair or, at its
discretion, replace this product without charge (except for a $3.00 charge for handling, packing, return UPS/postage, and insurance).
This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below.
The product must include proof of purchase, including date of purchase. The fee for service after the warranty period or without proof
of purchase is $6.00.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or defective batteries
are the most common cause of problems encountered.
If service is still required:
1. Remove batteries (if applicable) and pack the unit in a well-padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase.
3. Enclose a check or money order payable to the order of Soundesign, for the sum of $3.00 (or $6.00 if after the warranty period or
without proof of purchase).
4. Send the unit prepaid to the Factory Service Center listed below:
Consumer Repair Department
SDI Technologies Inc.
Timex Audio Products Division
1330 Goodyear Drive
El Paso TX 79936-6420
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which
have been damaged by negligence, misuse or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked
or broken cabinets, or units damaged by excessive heat; (iii) damage to tape cassettes (if applicable); (iv) the cost of shipping this product
to the Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the product subsequent to the original
purchaser. Any applicable implied warranties are also limited to 90 days, and SDI Technologies will not be liable for consequential
damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may
not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
© 2006 SDI Technologies, Inc. All rights reserved
TIMEX is a registered trademark of Timex Corporation the United States and other countries.
T435-092206-A
Printed in China
9
Operating the Alarms
Setting the Radio Alarm
1. Press the 
  Alarm Set Button once to set the radio alarm. The display will flash and show the radio alarm setting.
2. Press the 
 << or  >> Button to set the radio alarm time. Hold either button for a few seconds to advance or reverse the alarm
time rapidly. Set the correct AM/PM time, shown by the PM indicator; there is no AM indicator.
3. While the display is still flashing, press the 
 7-5-2 Button repeatedly until your desired alarm days are shown on the bottom of
the display.
Note: The 7-5-2 setting lets you set the alarm for a full week, weekdays only, or the weekend. Be sure that you have set the correct
day and date as shown in "Setting the Calendar".
4. See Listening and Sleeping to the Radio for instructions on selecting radio station and volume.
5. Press the 
 Alarm Set Button twice, or wait a few seconds to return to the standard clock display.
6.  Press the 
 Radio Alarm Button.The Radio Alarm Indicator will appear, showing that the radio alarm is set and armed.
Setting the Buzzer Alarm
1. Press the 
 Alarm Set Button twice to set the buzzer alarm. The display will flash and show the buzzer alarm setting.
2. Press 
the 
 << or  >> Button to set the buzzer alarm time. Hold either button for a few seconds to advance or reverse the alarm
time rapidly. Set the correct AM/PM time, shown by the PM indicator.
3. While the display is still flashing, press the 
 7-5-2 Button repeatedly until your desired alarm days are shown on the bottom of
the display.
Note: Follow the 7-5-2 setting information for Radio Alarm.
4. Press 
 Alarm Set Button once or wait a few seconds to return to the standard clock display.
5. Press the 
 Buzzer Alarm Button. The Buzzer Alarm Indicator will appear, showing that the buzzer alarm is set and armed.
Checking Your Alarm Time Settings
To check either alarm setting, press the 
 Alarm Set Button once to briefly see the radio alarm setting and twice to show the buzzer
alarm setting.
Turning Off the Alarms
1. After the alarm sounds, press the 
 Off/Alarm Reset Button to turn off the alarm while still maintaining the programmed 7-5-2
Alarm settings. To turn off an alarm, press its Alarm Button so that its Alarm Indicator no longer appears on the display.
2. If the 
 Off/Alarm Reset Button is not pressed, the alarm will sound for an hour before stopping. As long as an indicator appears
on the display, the alarm will sound according to the 7-5-2 Advance Alarm settings.
3. To use the snooze feature, press the 
 Snooze/Dimmer Button when alarm sounds. The alarm will stop for about nine minutes
before sounding again. This can be repeated during the one-hour snooze cycle.
Note:
 
The manufacturer is not responsible for any radio or TV interference
cause by unauthorized modifications to this equipment. Such modification
could void the user’s authority to operate the equipment.
CAUTION: 
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING: 
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
The lightning flash with arrowhead in an equilateral triangle is intended to alert the
user of the presence of uninsulated “dangerous voltage” within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the user of
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
The symbols above are located at the bottom of the cabinet.
CAUTION:  To prevent electric shock, match wide blade of plug to wide
slot.  Fully insert.
ATTENTION:  Pour éviter les choc électriques. Introduire la lame la plus
large de la fiche dans la borne correspondante de la prises et pousser
jusqu’au fond.
This device complies with part 15 of the FCC Rules. Operation is subject to the
condition that this device does not cause harmful interference.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
2