Timex t156 Leaflet

The Alarm Clock operates on 3 “AA” (R6) batteries,

which are included is for demo purpose only. To replace

or install the batteries, follow these instructions:
Install The Battery:
1.  The battery compartment is located on the back

of the cabinet. Open the battery compartment

door by screw driver then take out the battery

box.

2. Install 3 “AA” (R6) batteries, making sure that the

positive and negative polarities match up with

the diagram inside the battery box.

3.  Put back the battery box into battery

compartment gently and in correct direction.

4. .Close the battery compartment door by screw

driver. Do not over-tighten.

For the Best Possible Performance:
• We recommend using alkaline batteries.
•  Non-rechargeable batteries are not to be

recharged.

• Rechargeable batteries are to be removed from

the clock before being charged (if removable).

• Different types of batteries or new and used

batteries are not to be mixed.

• Only batteries of the same or equivalent type as

recommended are to be used.

• Remove exhausted batteries from the clock.
• The supply terminals are not to be short-circuited.
• Rechargeable batteries are only to be recharged

under adult supervision. (if removable)

• Batteries are to be inserted with correct polarity.

Note:  While  pressing  either FWD or

REV Button the minutes will begin at a

moderate pace, then get faster. This will

assist you in setting the time both fast and

exact.

3. Press either the FWD or REV Button

repeatedly until the correct time is displayed.

Setting Alarm Time

1. Press and hold the Alarm Set/Reset

Button for several seconds until the display

flashes. If no alarm-set buttons are pressed

within approx. ten seconds, the display will

stop flashing and return to normal mode.

2.  Press and hold the FWD Button to rapidly

advance the alarm time forward, or the

REV Button to rapidly change the alarm

time backward. Release button when the

approximate alarm time is displayed. PM

Indicator is on the lower right of the

display. Again, be sure to set the proper

AM or PM wake time as shown by PM

Indicator.

3. Press either the FWD or REV Button

repeatedly until the desired alarm time is

displayed.

4.  When the alarm time has been set, press

the Alarm Set/Reset Button again to

return to the default clock display.

Installing the Batteries

All of the clock and alarm functions are controlled

using the buttons in the front of cabinet (see graphic)

Setting Clock Time
1.  Press and hold the Time Button for several

seconds until the display flashes. If no time-

set buttons are pressed within approx. ten

seconds, the display will stop flashing and

return to normal mode.

2. 

Press and hold the FWD Button to rapidly

advance the time forward, or the REV Button

to rapidly change the time backward. Release

button when the approximate correct time is

displayed. PM Indicator is on the lower right

of the display.

Setting Clock Time and Alarm Time

Operating the Alarm

Turning On the Alarm

1.  After setting the alarm time, set the Mode

Switch to Alarm ON to turn on the alarm.

The Alarm ON Indicator Icon will appear

on the display, showing that the alarm is

turning on.

2. Set the Volume Switch to Hi for louder

alarm sound and shaking effect during

alarm sounding. Set to Low for lower alarm

sound and no shaking effect.

Turning Off the Alarm
1.  After the alarm sounds, press the Alarm

Set/Reset Button to turn it off and

automatically reset it for the same time the

following day.

Alarm Set/

Reset Button

FWD Button

REV Button

Time Button

Snooze/Light Button

Volume Switch

Mode Switch

TIME SET

REV

ALARM  SET / RESET

FWD