Timex T035 User Manual
Operating Instructions
3
Setting The Clock To The Correct Time of Day
The clock symbol in the upper left corner of the display indicates that the display is showing current time. The bell
symbol in the upper left corner of the display indicates that the display is showing the wake-up time. Pressing the MODE
button cycles the display between the current time and wake-up time.
1. If necessary press the MODE button to change the display to the current time mode. appears in the display.
2. Press the SET button. The lighting turns on briefly and the hour digits begin to flash. Press the UP or DOWN buttons to
symbol in the upper left corner of the display indicates that the display is showing the wake-up time. Pressing the MODE
button cycles the display between the current time and wake-up time.
1. If necessary press the MODE button to change the display to the current time mode. appears in the display.
2. Press the SET button. The lighting turns on briefly and the hour digits begin to flash. Press the UP or DOWN buttons to
adjust the hour. Be sure to set correctly for AM or PM.
3. Press the SET button again. The minutes begin to flash. Press the UP or DOWN buttons to adjust the minutes.
4. Press the SET button again. The Year begins to flash at 2011. Press the UP button to adjust the year if necessary.
5. Press the SET button again. The Month display begins to flash. Press the UP or DOWN buttons to adjust the month (1 =
4. Press the SET button again. The Year begins to flash at 2011. Press the UP button to adjust the year if necessary.
5. Press the SET button again. The Month display begins to flash. Press the UP or DOWN buttons to adjust the month (1 =
January, 2 = February, etc)
6. Press the SET button again. The Date display begins to flash. Press the UP or DOWN buttons to adjust the date. The
DAY indicator changes automatically to match the Year, Month, and Date display.
When you are finished with the above settings you can press the SET button again to exit the setting mode and start the
clock running. Or, after 60 seconds the clock automatically exits the setting mode and begins to run. Note: The flashing colon
between the hour and minute digits acts as a seconds counter.
clock running. Or, after 60 seconds the clock automatically exits the setting mode and begins to run. Note: The flashing colon
between the hour and minute digits acts as a seconds counter.
Indoor Temperature Display
This clock includes a built in temperature sensor and indoor temperature display. The indoor temperature can be displayed
in Centigrade (C°) or Fahrenheit (F°). The initial default setting when the batteries are installed is Centigrade. To switch the
display between Centigrade and Fahrenheit press the DOWN button. Note: If you place this clock on a windowsill or similar
location where it may be exposed to direct sunlight or cold winter temperatures you will not get an accurate room
temperature reading.
in Centigrade (C°) or Fahrenheit (F°). The initial default setting when the batteries are installed is Centigrade. To switch the
display between Centigrade and Fahrenheit press the DOWN button. Note: If you place this clock on a windowsill or similar
location where it may be exposed to direct sunlight or cold winter temperatures you will not get an accurate room
temperature reading.
12/24-Hour Time Display
This clock can display the time in 12-hour format with AM/PM indicators, or in 24-hour format, often referred to as ‘military
time’. To switch the display between 12 and 24-hour time formats, press the UP button.
time’. To switch the display between 12 and 24-hour time formats, press the UP button.
Momentary Lighting System
Each time you press any front panel button to make adjustment the lighting will turn on for approximately 5 seconds and the
shut off automatically to extend the battery life.
shut off automatically to extend the battery life.