Timex T035 User Manual
6
Operating Instructions
To program the countdown timer:
1. Press the TIMER button. The display will show 23 Hours, 59 Minutes, and 59 Seconds which is the initial default setting
for the timer. The TIMER indicator also appears.
2. Press the SET button. The Hour display begins to flash. Press the UP or DOWN buttons to set the number of hours
before the alarm turns ‘On’.
3. Press the SET button again. The Minute display begins to flash. Press the UP or DOWN buttons to set the number of
minutes before the alarm turns ‘On’.
4. Press the SET button again. The Seconds display begins to flash. Press the UP or DOWN buttons to set the number of
seconds before the alarm turns ‘On’.
5. When the display is showing the desired Hours, Minutes, and Seconds, press the TIMER button once to enter the new
timer setting in the memory, and once more to start the countdown timer. The display will begin counting down. Note: If
you want to pause the countdown at any time press the TIMER button again. Press the TIMER button once more to
resume the countdown.
you want to pause the countdown at any time press the TIMER button again. Press the TIMER button once more to
resume the countdown.
6. When the countdown has started you can press the MODE button to change the display back to the current time, or
after 60 seconds the display will change back to the current time automatically. To review the amount of countdown time
remaining, press the TIMER button at any time, and then press the MODE button to return to current time.
remaining, press the TIMER button at any time, and then press the MODE button to return to current time.
7. When the timer counts down to “00” the alarm will turn on and continue for one minute. To stop the alarm sooner, press
any button on the front panel.
NOTES:
• When you change the timer from the 23:59:59 default setting to a new setting, the new setting becomes the new default.
• When you change the timer from the 23:59:59 default setting to a new setting, the new setting becomes the new default.
For example, if you program the alarm to turn on after 90 minutes, this becomes the new default setting. The next time
you press the TIMER button the new default setting on the display will be 90 minutes.
you press the TIMER button the new default setting on the display will be 90 minutes.
• When the timer begins counting down the display and cabinet lighting will remain ‘On’ for 5 seconds and then shut off
automatically to extend the battery life.
Replacing the Batteries
When the display becomes dim and begins to fade and the volume of the sounds becomes weak you should replace the
batteries as soon as possible. If weak or exhausted batteries are left in the battery compartment they will eventually leak and
cause damage to the unit and possible damage to the surface below the unit as well.
batteries as soon as possible. If weak or exhausted batteries are left in the battery compartment they will eventually leak and
cause damage to the unit and possible damage to the surface below the unit as well.
Always replace all 3 batteries at the same time and do not mix different types of batteries.
IMPORTANT: Make sure you have the 3 new batteries removed from their package and ready to install before you remove
the old batteries from the unit. If you can replace the batteries within one minute you will not need to reset the clock. But if
there are no batteries in the battery compartment for more than one minute it will be necessary to reset all clock functions
after the new batteries are installed.
the old batteries from the unit. If you can replace the batteries within one minute you will not need to reset the clock. But if
there are no batteries in the battery compartment for more than one minute it will be necessary to reset all clock functions
after the new batteries are installed.