Panasonic RX-EX1 User Manual
RQT5671
22
Reference
Troubleshooting
Before requesting service, make the below checks. If you can’t fix the system as described below, or if something not listed
here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
For detailed instructions, contact an authorized servicenter in the U.S.A. and Panasonic Canada Inc. Customer Care
Centre in Canada.
In the U.S.A., call 1-800-211-7262, e-mail consumerproducts@panasonic.com, or visit www.panasonic.com
In Canada, call 905-624-5505 or visit www.panasonic.ca
Centre in Canada.
In the U.S.A., call 1-800-211-7262, e-mail consumerproducts@panasonic.com, or visit www.panasonic.com
In Canada, call 905-624-5505 or visit www.panasonic.ca
Reference pages are shown as black circled numbers
6
6
6
6
6.
Common problems
“E” is displayed
“UO1” is displayed
“UO2” is displayed
CD
CD won't play or CD display is incorrect
Cassette deck
Recording not possible
Poor sound quality
Radio
A lot of noise or difficult to tune
Remote control
The remote control doesn't work.
The unit can't be turned on from the remote
control.
Indicates incorrect operation. Read the instructions.
Replace the batteries or use household AC power.
6
Batteries haven't been inserted. Insert batteries or use household AC
power. (“UO2” appears only if you have inserted memory batteries.)
6
Clean the CD
Ä
Wait for about an hour for condensation to clear and try again.
Make sure the label is facing up.
Make sure the label is facing up.
Ä
Replace the CD if it is scratched, warped, or irregularly shaped.
Ä
Have the cassette's tabs been removed? Cover the holes with tape.
Ü
Clean the heads.
9
Interference may be caused by other equipment. Turn the other equipment
off or separate this unit from them.
Interference may occur if a remote control from other equipment is used.
Interference may occur if a remote control from other equipment is used.
Check the batteries are inserted correctly.
8
Replace the batteries if they are worn.
8
Use the power button on the main unit if you are using batteries to power
the unit.
6 8
General
Speakers
Full Range
7 cm 5.4
Ω
X
2
Jacks
Output
PHONES: 3.5 mm stereo (16–64
Ω)
Power requirement
AC
120 V, 60 Hz
Power consumption: 17 W
In standby mode: 1.2 W
Battery
12 V (Eight R20, D, UM-1 batteries)
Memory back-up for computer/clock
6V (Four R6, AA,UM-3 batteries)
Dimensions (W
X
H
X
D)
380
×
158
×
250 mm
14
31/32
˝
×
6
7/32
˝
×
9
27/32
˝ inch
Mass
3.7 kg (8.2Ibs)
without batteries
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Mass and dimensions are approximate.
Specifications
Radio
Frequency range
FM
87.9–107.9 MHz (200 kHz steps)
87.5–108.0 MHz (100 kHz steps)
87.5–108.0 MHz (100 kHz steps)
AM
520–1710 kHz (10 kHz steps)
CD player
Sampling frequency
44.1 kHz
Decoding
16 bit linear
Beam source
Semiconductor laser (wavelength 780 nm)
No. of channels
2 channel, stereo
Wow and flutter
Below measurable limit
D/A converter
MASH (1 bit DAC)
Tape recorder
Track system
4 track, 2 channel, stereo
Monitor system
Variable sound monitor
Recording system
AC bias
Erasing system
Multi Pole magnet
Frequency response
Normal position
50 Hz–14 kHz
re-ex1(p16-p22)[P]
7/27/01, 12:03 PM
22