Clarke SCRUBTEC 743L User Manual

REAR BLADE

0.06 (1.5 mm)

To remove the squeegee, follow this procedure:

1.  Remove the squeegee assembly by loosening the two

knobs that attach the squeegee to the machine.  Pull
the squeegee assembly off (See figure 37).

2.  Inspect the squeegee blade.

3.  If the blade is worn, turn the blade so that a new edge

is in the wiping position.

4.  Reinstall squeegee assembly on the machine.

The following adjustments are set at the factory, however
they may require slight adjustment.

Adjusting Squeegee Tilt:
The tilt of the squeegee causes the rear blade to raise up
in the center or on the ends, depending on which
direction the tilt is changed.  For tilt adjustment, refer to
figure 38.  Loosen left and right screw "X".  In order to
bring the blades down in the center, tip "Y" down.  To
bring both ends down, tip "Y" up.  Make very small
adjustments and try it until a uniform flare is achieved.

Adjusting Squeegee Blades:
When properly installed the front blade should be ap-
proximately 0.06" (1.5mm) above the rear blade (See
figure 39).

authorized personnel only.

Consult your authorized service person to do the
service procedures.

Use only genuine ALTO parts.