Blomberg TKF 8439 A User Manual

23 EN

There are humidity sensors in your dryer 

that detect whether the laundry is dry or 

not.

To clean the sensor:

1.  Open the loading door of the dryer.

2.  Allow the machine to cool down if 

drying has been carried out.

3.  Wipe the metal sensors with a soft 

cloth, dampened with vinegar and dry 

them.

C  Clean metal sensors 4 times a year.

A Never use solvents, cleaning agents 

or similar substances when cleaning 

since these materials can cause fire and 

explosion! 

The moisture in the damp laundry is taken 

from the laundry and condens ed. Drain 

the water tank after each drying cycle or 

during drying when “Water tank” warning 

light turns on.

A Condensed water is not drinkable!

A Never take out the water tank when the 

programme is running!

-  Inside the drawer on the panel

-  Behind the kick plate cover

If you forget to drain the water tank, your 

dryer will stop during the following 

drying cycles when the water tank is 

full and the “Water tank” warning light 

will turn on. If this is the case, press the 

“Start/Pause/Cancel” button to resume 

the drying cycle after draining the water 

tank.

To drain the water tank:

1.  Drain the water  as shown on the 

picture .

Lint and fibres released from the laundry to 

the air during the drying cycle are collected 

in the “Filter Cartridge”. 

CSuch fibre and lint are generally formed 

during wearing and washing.

C  Always clean the filter and the inner 

surfaces of the cover after each drying 

process.

C  You can clean the filter and filter area by 

vacuum cleaner.

To clean the filter:

1.  Open the loading door.

2.  Remove the cover filter by pulling it up 

and open the filter.

3.  Clean lint, fibre, and cotton raveling by 

hand or with a soft piece of cloth. 

4.  Close the filter and place it back into its

seat.

C Clogging may arise on the filter surface 

after using your machine for some time; 

if this occurs, wash the filter with water 

and dry it before using again. 

C Clean the entire inner surface of the 

cover and door gasket.