Beko DC 7100 User Manual

18 EN

Lint and fibres released from the laundry to the 

air during the drying cycle are collected in the 

“Filter Cartridge”. 

C

 Such fibre and lint are generally formed 

during wearing and washing.

C

 Always clean the filter and the inner surfaces 

of the cover after each drying process.

C

 You can clean the filter and filter area by 

vacuum cleaner.

To clean the filter:

1.  Open the loading door.

2.  Remove the cover filter by pulling it up and 

open the filter.

3.  Clean lint, fibre, and cotton raveling by hand 

or with a soft piece of cloth. 

4.  Close the filter and place it back into its

seat.

C 

Clogging may arise on the filter surface after 

using your machine for some time; if this 

occurs, wash the filter with water and dry it 

before using again. 

C 

Clean the entire inner surface of the cover 

and door gasket.

The moisture in the damp laundry is taken from 

the laundry and condens ed. Drain the water 

tank after each drying cycle or during drying 

when “Water tank” warning light turns on.

A

Condensed water is not drinkable!

A

Never take out the water tank when the 

programme is running!

If you forget to drain the water tank, your dryer 

will stop during the following drying cycles 

when the water tank is full and the “Water 

tank” warning light will turn on. If this is the 

case, press the “Start/Pause/Cancel” button to 

resume the drying cycle after draining the water 

tank.

*To drain the water tank:

1-Carefully remove the water tank by opening 

the kick plate cover/pulling the drawer.

2-Drain the water in the tank

3-If there is lint accumulation in the funnel of the 

water tank, clean it under running water.

4-Place the water tank into its seat.