Smeg 129316 User Manual
129316
•
Press the START/PAUSE button (D) - LED E is
on, appliance starts to operate (after a 2 second
pause).
pause).
•
10 minutes prior the end of drying program the
machine starts the cooling cycle (heater is off),
which prevents excessive creasing.
which prevents excessive creasing.
•
At the end of the cooling program the appliance
switches on the anti-crease program, which lasts
for 1 hour (periodic tumbling of the drum); LED (E)
is fl ashing.
for 1 hour (periodic tumbling of the drum); LED (E)
is fl ashing.
•
If you open the dryer door the anti-crease
program is suspended.
- End of drying
At the end of drying LED (E) fl ashes,
which means that the drying program
is completed. LED (F) is on, which for
the evacuation type of dryer requires
cleaning of fi lter, and for the condensation
type cleaning the fi lter and draining the
container.
is completed. LED (F) is on, which for
the evacuation type of dryer requires
cleaning of fi lter, and for the condensation
type cleaning the fi lter and draining the
container.
•
Open the dryer door by pushing the left-hand side
of the door towards the appliance.
•
Remove the laundry from the dryer.
•
Turn the appliance off by turning the jog selector
(A) to the position “0”.
•
Clean the lint fi lter (see chapter on Cleaning and
Maintenance).
•
Close the dryer door.
•
Empty the water container (this applies for
condensation dryers only - see Cleaning and
Maintenance) and replace it back to its slot.
Maintenance) and replace it back to its slot.
•
Pull the power lead from the socket, disconnecting
the appliance from the mains.
12
Drying procedure