Smeg AS 63 CS User Manual

12 - EN

Problem

Cause

Explanation / Suggestion

Drying process takes

too much time. 

Cover filter and filter drawer might have

not been cleaned.

* Clean the cover filter and Filter drawer.

Laundry come out wet 

at the end of drying.

* Cover filter and filter drawer might

have not been cleaned.

* Excessive laundry might have been

loaded in.

* Clean the cover filter and Filter drawer.

* Do not overload the machine.

Machine does not 

switch on or the 

program does not 

start. Machine is not 

activated when set.

* It might have not been plugged in.

* The loading door may be ajar.

* Program might have not been set or

the “Start/Pause/Cancel” button might

have not been pressed.

* “Childproof lock” might have been

activated.

* The condenser cover on the models

with a condenser might not be closed 

securely.

* Make sure that the machine is plugged

in.

* Make sure that the loading door is

properly closed.

* Make sure that the program has been

set and it is not in “Pause” mode.

* Deactivate the childproof lock.

* Make sure that the condenser cover

and the red lock is closed securely.

Program has been 

interrupted without 

any cause.

* The loading door may be ajar.

* Electricity may be cut off.

* Make sure that the loading door is

properly closed.

* Press “Start/Pause/Cancel” button to

start the program.

Laundry has shrunk, 

become felted or 

deteriorated.

* A program suitable for the laundry

type might have not been used.

* Dry only the laundry which is suitable

for drying in your machine after checking 

the labels on your clothes.

* Select a program with suitable low

temperature for the laundry type to dry 

your clothes.

Drum lightning does

not come on.

(for models equipped 

with a lamp)

* The machine might have not been

started by using the On/Off button.

* Bulb may have blown.

* Make sure that the machine is On.

* Call the authorized service to replace

the bulb.

“Final / Anti-creasing”

LED flashes.

* The 2-hour anti creasing program to

prevent laundry from creasing might 

have been activated.

* Turn off the machine and take out the

laundry.

“Final / Anti-creasing”

LED is on.

* Program has come to an end.

* Turn off the machine and take out the

laundry.

The “Drying” LED

flashes.

* A heat sensor failure has occurred.

Machine ends the program without 

heating.

* Turn off the machine and take out the

laundry. Call your authorized service.

Also for products equipped with a condenser

“Water tank” warning

LED is on.

* Water may be full.

* Anti-creasing program might be

running.

* Drain the water in the water tank.

“Filter cleaning” LED

is on.

* Filter might have not been cleaned.

* Clean the cover filter.

“Condenser cleaning”

LED is on.

* Filter drawer/Condenser might have

not been cleaned.

* Clean the filters in the condenser/filter

drawer under the kick plate.

A

Call an authorized service if the problem persists.