Sterling 882.00290.00 User Manual

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Note: To clean the cooling coil, use compressed air or a steam cleaner to blow the dust off or 

clean any oily residue on the coil. 

1. Shut down the dryer, tag out and lock out the controls if necessary. 

2. Shut the water off to the cooling coil. 

3. Remove the four 10-32 bolts. 

4. Gently slide the cooling coil out. 

5. Visually inspect the coil for leaks, dirt, and ant sign of volatiles. 

6. Blow the dust out, or if the coil is covered with plasticizer, steam clean it. 

7. Place the coil back in its housing. Make sure the gasket is OK, replace if necessary. 

8. Inset the four 10-32 bolts back in place. 

9. Turn the water to the cooling coil back on. 

 

Undo (4) 10-32 Button 
Head Screws using 1/8 
Allen Wrench

Use compressed air or a steam 
cleaner to blow the dust off or clean 
any oily residue on the coil.

1" Wide x 1/8" Thick High 

Temperature Gasket

Water flow requirement:
    If used as an After-Cooler: 3 to 4 GPM @80F.
    If used as a Plasticizer Trap: 3 to 4 GPM @ 40F to 45F.

Dehumidifying Dryers 

Chapter 5: Maintenance 

41 of 53