Hoover condenser tumble dryer User Manual
DOOR and FILTER
Opening the Door
Pull on handle to open
the door.
the door.
To restart the dryer,
close the door and
p r e s s S t a r t / P a u s e
button .
close the door and
p r e s s S t a r t / P a u s e
button .
WARNING! When the tumble dryer is in
use the drum and door may be VERY HOT.
Never stop a tumble dryer before the end of the
drying cycle unless all items are quickly
removed and spread out so that the heat is
dissipated.
Never stop a tumble dryer before the end of the
drying cycle unless all items are quickly
removed and spread out so that the heat is
dissipated.
Filter Care Indicator
Lights when the
filter needs cleaning.
filter needs cleaning.
If the laundry is not
drying check that the
filter is not clogged.
drying check that the
filter is not clogged.
DO NOT USE WATER TO CLEAN THE FILTER.
Filter
IMPORTANT: To maintain the efficiency of the
dryer check that the fluff filter is clean before
each drying cycle.
dryer check that the fluff filter is clean before
each drying cycle.
1 . P u l l t h e f i l t e r
upwards.
upwards.
2. Open filter as shown.
3.Gently remove lint
using a soft brush or
your fingertips.
using a soft brush or
your fingertips.
4 . S n a p t h e f i l t e r
together and push
back into place.
together and push
back into place.
EN
9
WATER CONTAINER
The water removed from the laundry during the
drying cycle is collected in a container at the
bottom of the dryer. When the container is full
the indicator on the control panel will light,
and the container MUST be emptied. However,
we recommend that the container is emptied
after each drying cycle.
drying cycle is collected in a container at the
bottom of the dryer. When the container is full
the indicator on the control panel will light,
and the container MUST be emptied. However,
we recommend that the container is emptied
after each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.
first few cycles of a new machine as an internal
reservoir is filled first.
To Remove the Container
1.Gently pull the bottom
of the kickplate so that it
unclips from the dryer.
The top section can
t h e n b e u n h i n g e d
allowing the kickplate to
b e c o m p l e t e l y
removed.
of the kickplate so that it
unclips from the dryer.
The top section can
t h e n b e u n h i n g e d
allowing the kickplate to
b e c o m p l e t e l y
removed.
2.Pull firmly on the
handgrip and slide the
water container out of
the dryer
.
Support the container
with both hands. When
full, the water container
will weigh about 4kg.
handgrip and slide the
water container out of
the dryer
.
Support the container
with both hands. When
full, the water container
will weigh about 4kg.
3. Open the lid located
on the top of the
container and empty
the water.
on the top of the
container and empty
the water.
4. Refit the lid and slide
the water container
back into position.
PUSH FIRMLY INTO
PLACE.
the water container
back into position.
PUSH FIRMLY INTO
PLACE.
5. Refit the kickplate by
engaging the hinges at
the top and 'snapping'
the lower clips into
place.
engaging the hinges at
the top and 'snapping'
the lower clips into
place.