KitchenAid KEHS01P User Manual

Gather the required tools and parts before starting installation. 
Read and follow the safety instructions provided with any tools 
listed here.

Remove parts packages from dryer drum. Check that all parts are 
included.

NOTE: Do not use leveling legs if installing the dryer on a 
pedestal.

Check local codes. Check existing electrical supply and venting.  
See “Electrical Requirements” and “Venting Requirements” 
before purchasing parts.

■

For close-clearance installations between 31.5" (80.01 cm) 
and 37" (93.98 cm), see “Plan Vent System” section for 
venting requirements.

Mobile home installations require metal exhaust system hardware 
available for purchase from the dealer from whom you purchased 
your dryer. For further information, please refer to the “Assistance 
or Service” section of this manual.

Are you placing the dryer on a pedestal? You may purchase a 
pedestal separately for this dryer. This pedestal will add about 
13" (33 cm) to the height of your unit for a total height of 
approximately 51" (130 cm). 

To order, call the dealer from whom you purchased your dryer or 
refer to the “Assistance or Service” section of this manual. Ask 
for Part Number LAB2700PMT (Meteorite) or LAB2700MQ0 
(White).

Are you planning to stack your washer and dryer? To do so, you 
will need to purchase a Stack Kit.

To order, call the dealer from whom you purchased your dryer or 
refer to the “Assistance or Service” section of this manual. Ask 
for Part Number 8541503.

■

A location that allows for proper exhaust installation. See 
“Venting Requirements.”

■

A separate 30 amp circuit.

■

A grounded electrical outlet located within 2 ft (61 cm) of 
either side of the dryer. See “Electrical Requirements.”

■

Flat-blade screwdriver

■

Adjustable wrench that 
opens to 1" (2.5 cm) or 
hex-head socket wrench 
(for adjusting dryer feet)

■

Level

■

Wire stripper (direct wire 
installations)

■

#2 Phillips screwdriver

■

Vent clamps

■

Caulking gun and 
compound (for installing 
new exhaust vent)

■

Tin snips (new vent 
installations)

■

¼" nut driver