Electrolux 134709300 User Manual

Reversing Door

 1  Be sure you have adequate swing area before reversing door.
  2  You will need a screw driver with a #2 square bit.
 3  Protect flat work surface, such as top of dryer or floor near dryer,

with a soft cloth or towel.

 4  Be sure dryer is unplugged from power source!

       WARNING

ELECTRICAL SHOCK HAZARD

Failure to disconnect power source before servicing 
could result in personal injury or even death.

A) Removing Trim Ring

  1  Open door to 90 degree angle.
  2  Remove and save trim plug and long, 

course-thread, panhead screw. 

  3  Close door.
 4  Rotate door trim approximately ¾” counter-

clockwise and pull ring away from door.

 4  Gently place door face down on flat, covered

work surface. 

  3  While supporting door with the other hand, 

remove 3 short, fine-thread, counter-sunk 
screws.

B) Removing Door from Front Panel

  1  Reopen door to 90 degree angle.
  2  Remove 2 short, course-thread, panhead 

screws.

Screwdrivers with

#2 square &

straight bit